Bogen LUMDMU manual Installation Steps, Have Required Tools

Page 5

3	Have Required Tools

The following tools are required for the installation of the MDMU hardware an cabling.

■Phillips screwdriver (small and large)

■Standard blade screwdriver (small and large)

■Wire strippers (24 AWG - 12 AWG)

■Telephone test set

■Tone out circuit tester (optional, for troubleshooting)

■Volt-ohm Meter (optional for troubleshooting)

■4 wood screws, if mounted on wall

Installation Steps

1 Mount the MDMU to either a wall, cabinet or a rack (near the paging equipment if possible).

Figure 1. Wall Mounted Unit

2

Image 5

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start IntroductionHave Required Tools Installation StepsRack Mounted Mdmu Connect the Mdmu to the Telephone SystemMdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer toPush the Battery slide switch to the on position Power Up SystemRecording Messages Controls and IndicatorsFront Panel Operation When recording is complete, press the Func key Listening to Recorded Messages Press the Func button until Play is displayed Playing MessagesPress the RUN button Than MSG-01 to playPlaying Messages in Sequence You are configured for 8 seePress the Func button to select a message other Press RUN to play and group the messageAdding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message SequencePress the Func button until Time appears Checking Message TimesAudio and Memory Tests Reset Delay Times to DefaultTest Button to end the continuous audioButton until Test appears Button to select the memory testTelephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions SpecificationsPIN Wire Colors Definition Blue White J1 Ring Orange