Bogen LUMDMU manual Table of Contents

Page 3

Table of Contents

Introduction	1
Before You Start	1
Installation Steps	2
Power Up System	6
Front Panel Operation	7
■ Controls and Indicators	7
■ Recording Messages	7
■ Listening to Recorded Messages	9
■ Playing Messages	10
■ Playing Messages in Sequence	11
■ Adding a Time Delay Between Message Plays	12
■ Clearing a Message Sequence	13
■ Checking Message Times	14
■ Reset Delay Times to Default	15
■ Audio and Memory Tests	15
Audio Test	15
Memory Test	16
Telephone Access Operation	17
■ Recording Messages	17
■ Listening to Recorded Messages	17
■ Playing Messages	18
■ Clearing a Message Sequence	18
Specifications	19

iii

Image 3

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start IntroductionHave Required Tools Installation StepsRack Mounted Mdmu Connect the Mdmu to the Telephone SystemMdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer toPush the Battery slide switch to the on position Power Up SystemControls and Indicators Front Panel OperationRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Than MSG-01 to play Playing MessagesPress the Func button until Play is displayed Press the RUN buttonPress RUN to play and group the message You are configured for 8 seePlaying Messages in Sequence Press the Func button to select a message otherAdding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message SequencePress the Func button until Time appears Checking Message TimesAudio and Memory Tests Reset Delay Times to DefaultButton to select the memory test Button to end the continuous audioTest Button until Test appearsTelephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions SpecificationsPIN Wire Colors Definition Blue White J1 Ring Orange