Bogen LUMDMU manual Checking Message Times, Press the Func button until Time appears

Page 17

Checking Message Times

The TIME function displays the time used for each message recorded. It also displays the remaining time available in system memory to record other messages.

1

2

Press the FUNC button until TIME appears.

TIME

Press the RUN button (once) to view message numbers and recording time.

MSG-01

Message number.

mm:ss

Time used to record message in minutes and seconds.

3 Once all messages and times are displayed, the display indicates:

LEFT

Amount of time left on the system to record other messages.

2:09

Available MDMU memory time in minutes and seconds.

DONE

14

Image 17

Contents Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start IntroductionHave Required Tools Installation StepsRack Mounted Mdmu Connect the Mdmu to the Telephone SystemMdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer toPush the Battery slide switch to the on position Power Up SystemRecording Messages Controls and IndicatorsFront Panel Operation When recording is complete, press the Func key Listening to Recorded Messages Press the Func button until Play is displayed Playing MessagesPress the RUN button Than MSG-01 to playPlaying Messages in Sequence You are configured for 8 seePress the Func button to select a message other Press RUN to play and group the messageAdding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message SequencePress the Func button until Time appears Checking Message TimesAudio and Memory Tests Reset Delay Times to DefaultTest Button to end the continuous audioButton until Test appears Button to select the memory testTelephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions SpecificationsPIN Wire Colors Definition Blue White J1 Ring Orange