Giant 1-Feb manual Installing the Hub on a Wall

Page 12

Installing the Hub on a Wall

Installing the Hub on a Wall

This section describes how to attach the hub in parallel and vertically to a wall.

Note Be sure the hub is powered off and is not connected to a power source before you perform the steps in the sections that follow.

Attaching the Brackets to the Hub

The bracket orientation depends on whether you plan to parallel or vertical wall-mount the hub:

For a parallel wall-mount, use the Phillips truss-head screws to attach the short side of the bracket to the hub.

For a vertical wall-mount, use the Phillips flat-head screws to attach the long side of the bracket to the hub.

Place the hub on a level surface, and use two of the Phillips truss-head or flat-head screws to attach a mounting bracket to each side of the hub.

Figure 2-6 shows how to attach one bracket to one side of the hub. Follow the same steps for the opposite side of the hub.

Figure 2-6 Attaching Brackets for Parallel and Vertical Wall-Mounting

OR REMOTE

SUPPLY

NMANUAL +12V @1A

For parallel wall-mounting

OR REMOTE

SUPPLY

N MANUAL

+12V

@1A

For vertical wall-mounting

Phillips

 

truss-head

 

screws

H10210

 

Phillips

flat-head

screws

H10211

2-12FastHub 400 10/100 Series Installation and Configuration Guide

Image 12
Contents Installing and Starting Up the Hub Page EMC Regulatory Statements TaiwanInstallation Guidelines and Requirements Unpacking the HubPackage Contents Powering Up the Hub and Running Post Installing the Hub on a Table or Shelf Installing the Hub in a Rack Attaching the Brackets to the HubAttaching Brackets for 19- and 24-inch Racks Mid-Mount Attaching the Hub to the Rack Attaching the Hub to a Rack Front Panel ForwardAttaching the Cable Guide to the Bracket Attaching a Cable GuideInstalling the Hub on a Wall Attaching Brackets for Parallel and Vertical Wall-MountingAttaching the Hub to a Wall Attaching the Hub to the WallConnecting to the Console Port FastHub 400M Models Connecting to the Console Port Assigning IP Information to the Hub FastHub 400M Models Enter the subnet mask IP netmask for exampleDefault gateway the router for the local subnet Connecting to the 10/100 Network Ports and Uplink Port Connecting to a 10/100 Port Accessing the Management Interfaces FastHub 400M Models Accessing the FastHub 400 Series Hub Manager Accessing the Management Interfaces FastHub 400M Models Home Accessing the CLI Accessing the MIB Files through SnmpUsing FTP to Access the MIB Files Using CCO to Access the MIB Files Where to Go Next