Giant 1-Feb manual Connecting to the Console Port

Page 15

Connecting to the Console Port (FastHub 400M Models)

Step 2 Connect one end of the supplied rollover console cable to the console port, as shown in Figure 2-8.

Caution Do not connect an actual telephone line, an ISDN line, or an Ethernet cable to this console port. Damage to the hub can result. Make sure you use the supplied RJ-45-to-RJ-45 rollover cable and adapters to connect the console port to the management station or modem.

Figure 2-8 Connecting to the Console Port

RATING

100-127

/ 200-240 V~

2A /1A

50 / 60 Hz

 

DC INPUTS FOR REMOTE

UP

POWER SUPPLY

SPECIFIED IN MANUAL

CONSOLE

+5V @6A, +12V @1A

 

DC INPUT

DOWN

 

MEDIA MODULE

Supplied RJ-45-to-RJ-45 rollover console cable

14256

Step 3 Attach the appropriate adapter, such as the supplied RJ-45-to-DB-9 female DTE adapter (labeled Terminal), to a management station or modem.

Note If you are connecting the hub to a Sun workstation (or to a management station with a female DB-25 serial connector), use a male-to-male gender changer to attach the supplied RJ-45-to-RJ-45 rollover cable and a RJ-45-to-DB-25 female DTE adapter to the management station.

Step 4 Connect the other end of the supplied rollover cable to the adapter.

Connector and cabling specifications for the console port are in the Appendix B, “Connector and Cable Specifications.”

Now that the hub is connected to a management station, you can assign IP information to the hub (see the “Assigning IP Information to the Hub (FastHub 400M Models)” section on page 2-16).

Installing and Starting Up the Hub 2-15

Image 15
Contents Installing and Starting Up the Hub Page Taiwan EMC Regulatory StatementsUnpacking the Hub Installation Guidelines and RequirementsPackage Contents Powering Up the Hub and Running Post Installing the Hub on a Table or Shelf Attaching the Brackets to the Hub Installing the Hub in a RackAttaching Brackets for 19- and 24-inch Racks Mid-Mount Attaching the Hub to a Rack Front Panel Forward Attaching the Hub to the RackAttaching a Cable Guide Attaching the Cable Guide to the BracketAttaching Brackets for Parallel and Vertical Wall-Mounting Installing the Hub on a WallAttaching the Hub to the Wall Attaching the Hub to a WallConnecting to the Console Port FastHub 400M Models Connecting to the Console Port Enter the subnet mask IP netmask for example Assigning IP Information to the Hub FastHub 400M ModelsDefault gateway the router for the local subnet Connecting to the 10/100 Network Ports and Uplink Port Connecting to a 10/100 Port Accessing the Management Interfaces FastHub 400M Models Accessing the FastHub 400 Series Hub Manager Accessing the Management Interfaces FastHub 400M Models Home Accessing the MIB Files through Snmp Accessing the CLIUsing FTP to Access the MIB Files Using CCO to Access the MIB Files Where to Go Next