Giant 1-Feb manual Assigning IP Information to the Hub FastHub 400M Models

Page 16

Assigning IP Information to the Hub (FastHub 400M Models)

Assigning IP Information to the Hub (FastHub 400M Models)

After you install the hub and connect it to a management station, you can assign IP information to the hub. IP information identifies the hub to the network and is required to manage and monitor the hub through the FastHub 400 series Hub Manager, the CLI, or SNMP.

You can assign IP information to the hub by following the hub start-up prompts displayed from a terminal emulation program on your management station.

You should contact your system administrator for the following information:

Hub IP address

Subnet mask (netmask)

Default gateway (router)

To assign IP information to the hub, follow these steps:

Step 1 From your management station, start the terminal emulation program.

After POST completes, the Continue with configuration dialog? prompt appears on the management station, and you can then follow the prompts to assign IP information to the hub.

Step 2 From the terminal or PC, enter Y:

Continue with configuration dialog? [yes/no]: Y

Step 3 Enter the IP address (for example: 10.1.105.20):

Enter IP address: 10.1.105.20

Step 4 Enter the subnet mask (IP netmask) (for example: 255.255.255.0):

Enter IP netmask: 255.255.255.0

2-16FastHub 400 10/100 Series Installation and Configuration Guide

Image 16
Contents Installing and Starting Up the Hub Page EMC Regulatory Statements TaiwanInstallation Guidelines and Requirements Unpacking the HubPackage Contents Powering Up the Hub and Running Post Installing the Hub on a Table or Shelf Installing the Hub in a Rack Attaching the Brackets to the HubAttaching Brackets for 19- and 24-inch Racks Mid-Mount Attaching the Hub to the Rack Attaching the Hub to a Rack Front Panel ForwardAttaching the Cable Guide to the Bracket Attaching a Cable GuideInstalling the Hub on a Wall Attaching Brackets for Parallel and Vertical Wall-MountingAttaching the Hub to a Wall Attaching the Hub to the WallConnecting to the Console Port FastHub 400M Models Connecting to the Console Port Assigning IP Information to the Hub FastHub 400M Models Enter the subnet mask IP netmask for exampleDefault gateway the router for the local subnet Connecting to the 10/100 Network Ports and Uplink Port Connecting to a 10/100 Port Accessing the Management Interfaces FastHub 400M Models Accessing the FastHub 400 Series Hub Manager Accessing the Management Interfaces FastHub 400M Models Home Accessing the CLI Accessing the MIB Files through SnmpUsing FTP to Access the MIB Files Using CCO to Access the MIB Files Where to Go Next