Giant 1-Feb manual Using FTP to Access the MIB Files

Accessing the Management Interfaces (FastHub 400M Models)

•CISCO-SIBU-MANAGERS-MIB.my contains the MIB module for management interfaces on the FastHub 400M models.

•CISCO-SIBU-STACKABLE-DUAL-SPEED-HUB-MIB.my contains the MIB module that extends the REPEATER-MIB to manage Cisco low-end stackable repeater products.

If you are going to manage the hub by using SNMP and the MIB files, the Read and Write community strings need to be set. To do this, you can either

•Use the default community strings

—Read community string. The default is public.

—Write community string. The default is private.

•Assign community strings by using the SNMP Management Page or by using the snmp-server community command on the CLI.

Note Wait approximately 30 seconds for the changes to be saved to permanent storage before turning off the hub, or the changes might not be saved.

You can obtain a copy of the MIB files in the following ways:

•

•

Using File Transfer Protocol (FTP) to access the ftp.cisco.com server.

Using Cisco Connection Online (CCO) to access the cisco.com server.

Using FTP to Access the MIB Files

To obtain a MIB file, follow these steps:

Step 1 Use FTP to access the server ftp.cisco.com.

Step 2 Log in with the username anonymous.

Step 3 Enter your e-mail name when prompted for the password.

Step 4 At the ftp> prompt, change directories to /pub/MIBs.

Step 5 Use the get README command to display the readme file listing available files.

Step 6 Use the get MIB_filename command to get a copy of the MIB file.

2-24FastHub 400 10/100 Series Installation and Configuration Guide