Giant 1-Feb manual Accessing the CLI, Accessing the MIB Files through Snmp

Accessing the CLI

Accessing the CLI

You can access the CLI

•From a console terminal connected to the hub console port. For more information, see the “Connecting to the Console Port (FastHub 400M Models)” section on page 2-14.

•Through a Telnet session from a remote host by entering the telnet command and the name or IP address of the hub.

•Through a Telnet session by clicking Telnet on the hub manager Home Page.

When you access the CLI and a password has been defined, the following prompt is displayed:

Cisco Systems Console

Enter Password:

Enter the password. The hostname> prompt is displayed after you enter the correct password.

For complete information about the CLI, refer to the FastHub 400 10/100 Series Command Reference.

Accessing the MIB Files through SNMP

You can access the hub MIB files through SNMP. The following MIB files contain variables that can be set or read to provide information about the hub and the traps generated by the hub.

•RFC1213-MIB.my contains the MIB II (RFC 1213).

•ETHERLIKE-MIB.my contains the Ethernet Transmission MIB (RFC 1643).

•CISCO-CDP-MIB.my contains the CDP MIB.

•SNMP-REPEATER-MIB.my contains the standard MIB for managing the hub.

•RMON-MIB.my contains the RFC 1757 RMON (Groups 1, 2, 3, and 9). More information about RMON and the RMON groups is provided in the “Remote Monitoring” section on page 2-25.

•CISCO-SIBU-SIMPLE-UPGRADE-MIB.my contains the MIB module for upgrading the firmware on Cisco low-end devices.

Installing and Starting Up the Hub 2-23