Giant 1-Feb manual EMC Regulatory Statements, Taiwan

Page 3

EMC Regulatory Statements

Warning This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.

Warning When installing the unit, the ground connection must always be made first and disconnected last.

Warning Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury and equipment damage.

Warning Care must be given to connecting units to the supply circuit so that wiring is not overloaded.

Warning A voltage mismatch can cause equipment damage and may pose a fire hazard. If the voltage indicated on the label is different from the power outlet voltage, do not connect the chassis to that receptacle.

Warning Ultimate disposal of this product should be handled according to all national laws and regulations.

EMC Regulatory Statements

U.S.A.

U.S. regulatory information for this product is in the front matter and in Appendix E, “Translated Safety Warnings,” of this manual.

Taiwan

15456

Installing and Starting Up the Hub 2-3

Image 3
Contents Installing and Starting Up the Hub Page Taiwan EMC Regulatory StatementsUnpacking the Hub Installation Guidelines and RequirementsPackage Contents Powering Up the Hub and Running Post Installing the Hub on a Table or Shelf Attaching the Brackets to the Hub Installing the Hub in a RackAttaching Brackets for 19- and 24-inch Racks Mid-Mount Attaching the Hub to a Rack Front Panel Forward Attaching the Hub to the RackAttaching a Cable Guide Attaching the Cable Guide to the BracketAttaching Brackets for Parallel and Vertical Wall-Mounting Installing the Hub on a WallAttaching the Hub to the Wall Attaching the Hub to a WallConnecting to the Console Port FastHub 400M Models Connecting to the Console Port Enter the subnet mask IP netmask for example Assigning IP Information to the Hub FastHub 400M ModelsDefault gateway the router for the local subnet Connecting to the 10/100 Network Ports and Uplink Port Connecting to a 10/100 Port Accessing the Management Interfaces FastHub 400M Models Accessing the FastHub 400 Series Hub Manager Accessing the Management Interfaces FastHub 400M Models Home Accessing the MIB Files through Snmp Accessing the CLIUsing FTP to Access the MIB Files Using CCO to Access the MIB Files Where to Go Next