Giant 1-Feb manual Connecting to the Console Port FastHub 400M Models

Page 14

Connecting to the Console Port (FastHub 400M Models)

Connecting to the Console Port (FastHub 400M Models)

To connect the RJ-45 console port of a FastHub 400M model to a management station or modem, you must use the supplied RJ-45-to-RJ-45 rollover console cable and the appropriate adapter and follow these steps.

Note The rollover console cable and a RJ-45-to-DB-9 female DTE adapter are supplied with the hub. If your management station requires a different adapter—such as a RJ-45-to-DB-25 female DTE or RJ-45-to-DB-25 male DCE adapter—you must provide it.

Step 1 Configure the hub console port settings to match the management station or modem. These are the default settings of the console port:

9600 baud

8 data bits

1 stop bit

No parity

No flow control

You can change the console port characteristics of the hub from the web-based System Configuration Page (see the “Changing the System Configuration” section on page 3-40) or by using the terminal command from the CLI.

Note Make sure the settings of the console port and the management station or the modem match.

2-14FastHub 400 10/100 Series Installation and Configuration Guide

Image 14
Contents Installing and Starting Up the Hub Page EMC Regulatory Statements TaiwanInstallation Guidelines and Requirements Unpacking the HubPackage Contents Powering Up the Hub and Running Post Installing the Hub on a Table or Shelf Installing the Hub in a Rack Attaching the Brackets to the HubAttaching Brackets for 19- and 24-inch Racks Mid-Mount Attaching the Hub to the Rack Attaching the Hub to a Rack Front Panel ForwardAttaching the Cable Guide to the Bracket Attaching a Cable GuideInstalling the Hub on a Wall Attaching Brackets for Parallel and Vertical Wall-MountingAttaching the Hub to a Wall Attaching the Hub to the WallConnecting to the Console Port FastHub 400M Models Connecting to the Console Port Assigning IP Information to the Hub FastHub 400M Models Enter the subnet mask IP netmask for exampleDefault gateway the router for the local subnet Connecting to the 10/100 Network Ports and Uplink Port Connecting to a 10/100 Port Accessing the Management Interfaces FastHub 400M Models Accessing the FastHub 400 Series Hub Manager Accessing the Management Interfaces FastHub 400M Models Home Accessing the CLI Accessing the MIB Files through SnmpUsing FTP to Access the MIB Files Using CCO to Access the MIB Files Where to Go Next