Giant 1-Feb manual Accessing the FastHub 400 Series Hub Manager

Page 21

Accessing the FastHub 400 Series Hub Manager

Accessing the FastHub 400 Series Hub Manager

To access the hub manager, all you need is the IP information of the hub (and the password if one has been assigned). IP information for the hub is usually assigned when the hub is first started up after installation. (See the “Assigning IP Information to the Hub (FastHub 400M Models)” section on page 2-16.)

Note You can access the hub manager from a PC connected to one of the 10/100 ports. Therefore, make sure that you do not disable or otherwise misconfigure the port through which you are communicating with the hub. You might want to write down the port number to which you are connected. Make changes to the hub IP information with care.

To access the hub manager, follow these steps:

Step 1 Start Netscape Communicator (4.03 or higher) or Microsoft Internet Explorer (4.01 or higher).

Step 2 Ensure that the following browser features are enabled:

•Java

•JavaScript

•Set the caching of pages to Every time in Communicator or Every visit to the page in Internet Explorer.

Step 3 Enter the IP address of the hub in the Location field if you are using Communicator (the Address field if you are using Internet Explorer) to display the hub manager Home Page (Figure 2-10).

11187

Installing and Starting Up the Hub 2-21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Installing and Starting Up the Hub Page Taiwan EMC Regulatory StatementsUnpacking the Hub Installation Guidelines and RequirementsPackage Contents Powering Up the Hub and Running Post Installing the Hub on a Table or Shelf Attaching the Brackets to the Hub Installing the Hub in a RackAttaching Brackets for 19- and 24-inch Racks Mid-Mount Attaching the Hub to a Rack Front Panel Forward Attaching the Hub to the RackAttaching a Cable Guide Attaching the Cable Guide to the BracketAttaching Brackets for Parallel and Vertical Wall-Mounting Installing the Hub on a WallAttaching the Hub to the Wall Attaching the Hub to a WallConnecting to the Console Port FastHub 400M Models Connecting to the Console Port Enter the subnet mask IP netmask for example Assigning IP Information to the Hub FastHub 400M ModelsDefault gateway the router for the local subnet Connecting to the 10/100 Network Ports and Uplink Port Connecting to a 10/100 Port Accessing the Management Interfaces FastHub 400M Models Accessing the FastHub 400 Series Hub Manager Accessing the Management Interfaces FastHub 400M Models Home Accessing the MIB Files through Snmp Accessing the CLIUsing FTP to Access the MIB Files Using CCO to Access the MIB Files Where to Go Next
Top Page Image Contents