ViewSonic EXES-2000 manual Connection of station plug to jack, Mounting option unit Bl unit

Page 13

6-3 Connection of station plug to jack

2-pin plug

YC-602

HF-210M

Cover

2-pin jack

YC-601 (or YC-603)

Notes

(1) Use 4"×2" back box for YC-603.

(2) Terminals 1 and 2 inside the jack have no polarity.

CN2

6-4 Mounting option unit

(1)Bl unit

Insert the Bl unit into its exclusive bay and connect its connector to CN4 on the CC unit.

(LM unit)

(Bl unit) (CC unit)

(2)Mounting other option units than the Bl unit

Option units other than the BI-20 are all connected to the CC unit via a common bus and so, any bay can be used to mount them so far as it is not the one solely intended for the Bl unit. The EX-200 exchange has 5 bays for option units, while the FC-210 has 6 bays. Insert the option units in order, stating with the bay closest to the CC unit, and connect the connector as illustrated below.

Earth wire

YR-821

EX-200

FC-210

Notes

(1)No YR-821 cable is needed when a maximum of 5 option units is mounted.

(2)Connect an earth wire of the YR-821 to the earth terminal of the FC-210.

– 12 –

Image 13

Contents EX-200 Before Reading this Hand Book ContentsExamples of system configuration Description and featuresPower BGM distribution up to 3 channelsPower transformer unit PU-200 Remote control unit RC-20Central control unit CC-20 Line modem unit LM-20Installation of equipment Installing and adjusting proceduresSelection of the place to install Dimensions Installation of the exchangeInstalling FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate R51 or R59 390k ohms on the LM unit corresponding to Cable installationExchange Indoor ExchangeterminalStations boardAddition of LM unit Connection of equipmentEstablishment of the LM unit number Mounting LM unit For the system with up to 16 stationsLM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment PTT.C PTT control RC unit connectionDoor locking Radio Station EquipmentMaximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Connection for speaker station Service distanceVoltage selector Connection of power sourceInitial set-up and programming No programming Procedures of initial set-up and No programmingDoor remote control 2 circuits PA paging & power remote/3-channel general purpose controlTransfer Secretary transfer Hurry upEX-610/620/630 Registration of each functionHighest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency CallWill be heard Handset Station RegistrationTimes Be sure to depress Key Steadily Have this FunctionAllowed Stations Allowed Access to Speech MessageDoor Substation Registration Release finished? Secretary TransferMASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 PagingRepeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 PagingRegistration of Stations to Refuse Zone 3 Paging Step Speech and Function Tests Speech Test Performance TestMethod of Speech test Hands-free conversation Handset conversationTrouble-shooting at the time of installation Replace station Noise is heard from the stationDoor Substation Function Table for StationsStation Data Table Station Data Table3 0 6 1 3 5 6 C