ViewSonic EXES-2000 manual Installing FC-210 extension cabinet

Page 7

4-3 Installing FC-210 extension cabinet

Follow the procedures below to install the FC-210 cabinet:

Unscrew screws that hold the top case to a chassis at 4 places in the sides of a cabinet.

Insert attached brackets (2 pieces) into bracket	Fit bracket receptacles of the FC-210 into the
receptacles on the bottom case of the EX-200.	brackets.
	Fix the cabinet on the wall through fixing holes
	provided on its bottom case.
(EX-200)	Connect the connector CN-5 on the CC-20 card
	mounted in the EX-200 to the connector CN-4 on the
	printed circuit board of the FC-210 using the
	attached GND connector.
	Remove a rubber membrane of 2 bushings on the
	bottom case of the EX-200 and FC-210 to allow the
	cable entry.

Bracket

Bracket

Knock-out hole (for wiring)

(FC-210)

Note

(1)Since the YR-820 and YR-821 cables are to be used for connecting the FC-210 to the EX-200 exchange, there is a limit to spacing between the two units. You should allow for this limit and fix them according to dimensions shown at right when they are mounted on the wall.

(2)Allow for sufficient spacing for screwing and un-

screwing the top cover when mounting on the wall.	Knock-out hole (for wiring)	Dimensions
screwing the top cover when mounting on the wall.

– 6 –

Image 7

Contents EX-200 Before Reading this Hand Book ContentsBGM distribution up to 3 channels Description and featuresExamples of system configuration PowerLine modem unit LM-20 Remote control unit RC-20Power transformer unit PU-200 Central control unit CC-20Installation of equipment Installing and adjusting proceduresSelection of the place to install Dimensions Installation of the exchangeInstalling FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate Indoor ExchangeterminalStations board Cable installationR51 or R59 390k ohms on the LM unit corresponding to ExchangeMounting LM unit For the system with up to 16 stations Connection of equipmentAddition of LM unit Establishment of the LM unit numberLM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment Radio Station Equipment RC unit connectionPTT.C PTT control Door lockingMaximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Connection for speaker station Service distanceVoltage selector Connection of power sourceInitial set-up and programming No programming Procedures of initial set-up and No programmingSecretary transfer Hurry up PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits TransferEX-610/620/630 Registration of each functionHighest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency CallWill be heard Handset Station RegistrationTimes Be sure to depress Key Steadily Have this FunctionAllowed Stations Allowed Access to Speech MessageDoor Substation Registration Release finished? Secretary TransferMASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 PagingRepeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 PagingRegistration of Stations to Refuse Zone 3 Paging Step Handset conversation Performance TestSpeech and Function Tests Speech Test Method of Speech test Hands-free conversationTrouble-shooting at the time of installation Replace station Noise is heard from the stationDoor Substation Function Table for StationsStation Data Table Station Data Table3 0 6 1 3 5 6 C