ViewSonic EXES-2000 manual Door Substation Registration

Page 31

9. DOOR SUBSTATION REGISTRATION

DOOR SUBSTATION REGISTRATION

STEP 1

Touch

Function Code

New Registration?

YES

NO

					Allowed	Station	No.
					Touch
					Allowed Station		No.
					Touch
					Confirmation tone
				NO	New Registration finished?
					New Registration finished?
						YES
					Release?		NO
					Release?
						YES
					Allowed	Station	No.
					Touch
					Allowed	Station No.
					Touch
					Confirmation tone
				NO	Release finished?
					Release finished?
						YES
					Return
NOTES
1. To allow	all	the stations to	have this	function,		3. Re-start at Step 1 when mis-dialing occurs.
Touch				(Confirmation tone			(All other registrations remain valid.)
				(Confirmation tone
				will be heard.)
				will be heard.)
			10 times
Be sure	to	depress the	key	steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

– 30 –

Image 31

Contents EX-200 Before Reading this Hand Book ContentsBGM distribution up to 3 channels Description and featuresExamples of system configuration PowerLine modem unit LM-20 Remote control unit RC-20Power transformer unit PU-200 Central control unit CC-20Installation of equipment Installing and adjusting proceduresSelection of the place to install Dimensions Installation of the exchangeInstalling FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate Indoor ExchangeterminalStations board Cable installationR51 or R59 390k ohms on the LM unit corresponding to ExchangeMounting LM unit For the system with up to 16 stations Connection of equipmentAddition of LM unit Establishment of the LM unit numberLM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment Radio Station Equipment RC unit connectionPTT.C PTT control Door lockingMaximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Connection for speaker station Service distanceVoltage selector Connection of power sourceInitial set-up and programming No programming Procedures of initial set-up and No programmingSecretary transfer Hurry up PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits TransferEX-610/620/630 Registration of each functionHighest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency CallWill be heard Handset Station RegistrationTimes Be sure to depress Key Steadily Have this FunctionAllowed Stations Allowed Access to Speech MessageDoor Substation Registration Release finished? Secretary TransferMASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 PagingRepeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 PagingRegistration of Stations to Refuse Zone 3 Paging Step Handset conversation Performance TestSpeech and Function Tests Speech Test Method of Speech test Hands-free conversationTrouble-shooting at the time of installation Replace station Noise is heard from the stationDoor Substation Function Table for StationsStation Data Table Station Data Table3 0 6 1 3 5 6 C