ViewSonic EXES-2000 manual Stations Allowed Access to Paging

Page 26

4.STATIONS ALLOWED ACCESS TO PAGING

(All stations are registered for this function when initial set-up is made)

STATIONS ALLOWED ACCESS TO PAGING

STEP 1

Touch

						Function Code
									NO
						New Registration?
							YES
					Allowed		Station		No.
					Touch
					Allowed		Station		No.
					Touch
						Confirmation		tone
				NO	New	Registration		finished?
					New	Registration		finished?
							YES
						Release?			NO
						Release?
							YES
					Allowed		Station		No.
					Touch
					Allowed		Station		No.
					Touch
						Confirmation tone
				NO		Release finished?
						Release finished?
							YES
						Return
NOTES
1. To allow	all	the stations to	have this	function,				3. Re-start at Step 1 when mis-dialing occurs.
Touch				(Confirmation		tone			(All other registrations remain valid.)
				(Confirmation		tone
				will be heard.)
				will be heard.)
			10 times
Be sure	to	depress the	key	steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

– 25 –

Image 26

Contents EX-200 Contents Before Reading this Hand BookPower Description and featuresExamples of system configuration BGM distribution up to 3 channelsCentral control unit CC-20 Remote control unit RC-20Power transformer unit PU-200 Line modem unit LM-20Selection of the place to install Installing and adjusting proceduresInstallation of equipment Installation of the exchange DimensionsInstalling FC-210 extension cabinet Installation of PU-200 power supply unit For plate For case Switch boxWall Base Case Exchange Cable installationR51 or R59 390k ohms on the LM unit corresponding to Indoor ExchangeterminalStations boardEstablishment of the LM unit number Connection of equipmentAddition of LM unit Mounting LM unit For the system with up to 16 stationsLM unit wiring Mounting other option units than the Bl unit Connection of station plug to jackMounting option unit Bl unit BGM equipment Alarm tone, etcBl unit connection Door locking RC unit connectionPTT.C PTT control Radio Station EquipmentSerial data output PC unit connectionMaximum contact capacity 125 VA 125V AC or 30V DC 1A Tl unit connection SM unit number setting Service distance Connection for speaker stationConnection of power source Voltage selectorProcedures of initial set-up and No programming Initial set-up and programming No programmingTransfer PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits Secretary transfer Hurry upRegistration of each function EX-610/620/630Highest Executive Priority Touch Continuous Calling ToneWill be heard Times Be sure to depress Key Steadily Stations Allowed Access to Paging Stations Allowed Access to Emergency Call Allowed Station NoHandset Station Registration Will be heardHave this Function Times Be sure to depress Key SteadilyStations Allowed Access to Speech Message AllowedDoor Substation Registration Secretary Transfer Release finished?MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Registration of Station to Refuse Zone 1 Paging Dial Will be heard TimesRegistration of Stations to Refuse Zone 2 Paging Repeat twice Registration of next allowed stationRegistration of Stations to Refuse Zone 3 Paging Step Method of Speech test Hands-free conversation Performance TestSpeech and Function Tests Speech Test Handset conversationTrouble-shooting at the time of installation Noise is heard from the station Replace stationFunction Table for Stations Door SubstationStation Data Table Station Data Table3 0 6 1 3 5 6 C