ViewSonic EXES-2000 manual Handset Station Registration, Will be heard

Page 28

6. HANDSET STATION REGISTRATION

HANDSET STATION REGISTRATION

STEP 1

Touch

			Function Code
			New Registration?			NO
			New Registration?
			YES
			Handset Station		No.
			Touch
			Handset Station		No.
			Touch
			Confirmation	tone
		NO	New Registration	finished?
			New Registration	finished?
			YES
			Release?		NO
			Release?
			YES
			Handset Station No.
			Touch
			Handset Station		No.
			Touch
			Confirmation	tone
		NO	Release finished?
			Release finished?
			YES
			Return
NOTES
1. To allow all the stations to	have this	function,		3.	Re-start at Step 1 when mis-dialing occurs.
Touch		(Confirmation tone			(All other registrations remain valid.)
		(Confirmation tone
		will be heard.)
		will be heard.)
	10 times
Be sure to depress the	key	steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

– 27 –

Image 28

Contents EX-200 Contents Before Reading this Hand BookDescription and features Examples of system configurationPower BGM distribution up to 3 channelsRemote control unit RC-20 Power transformer unit PU-200Central control unit CC-20 Line modem unit LM-20Installation of equipment Installing and adjusting proceduresSelection of the place to install Installation of the exchange DimensionsInstalling FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate Cable installation R51 or R59 390k ohms on the LM unit corresponding toExchange Indoor ExchangeterminalStations boardConnection of equipment Addition of LM unitEstablishment of the LM unit number Mounting LM unit For the system with up to 16 stationsLM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment RC unit connection PTT.C PTT controlDoor locking Radio Station EquipmentMaximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Service distance Connection for speaker stationConnection of power source Voltage selectorProcedures of initial set-up and No programming Initial set-up and programming No programmingPA paging & power remote/3-channel general purpose control Door remote control 2 circuitsTransfer Secretary transfer Hurry upRegistration of each function EX-610/620/630Highest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Stations Allowed Access to Emergency Call Allowed Station NoHandset Station Registration Will be heardHave this Function Times Be sure to depress Key SteadilyStations Allowed Access to Speech Message AllowedDoor Substation Registration Secretary Transfer Release finished?MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Registration of Station to Refuse Zone 1 Paging Dial Will be heard TimesRegistration of Stations to Refuse Zone 2 Paging Repeat twice Registration of next allowed stationRegistration of Stations to Refuse Zone 3 Paging Step Performance Test Speech and Function Tests Speech TestMethod of Speech test Hands-free conversation Handset conversationTrouble-shooting at the time of installation Noise is heard from the station Replace stationFunction Table for Stations Door SubstationStation Data Table Station Data Table3 0 6 1 3 5 6 C