Uniden EXP 9100 specifications Mounting on a Standard Wall Plate, Mounting Directly on a Wall

Page 10

Mounting on a Standard Wall Plate

1. Plug one end of the Telephone Line Cord (supplied) into the “LINE IN” jack on the top of the Base Unit. Lay the cord inside the molded channel on the bottom of the Wall Mount Adapter connected to the Base Unit. (Put any excess line cord inside the Wall Mount Adapter.)

2.Plug the other end of the Telephone Line Cord into

the telephone wall jack.

3.Plug the AC Adapter cord

into the AC Adapter input jack on the Base Unit.

(Note: Use only the AC

Adapter supplied with the EXP 9100.) Place the cord inside the molded channel on the Wall Mount Adapter connected to the Base Unit.

4.Place the Base Unit on the two posts of the wall plate and slide downward to secure. Then hang the Handset on the Base Unit.

5.Plug the AC Adapter into a standard 120V AC wall outlet.

6.Route the power cord where it will not create a trip hazard, or where it will not become chafed and create a fire or other electrical hazards.

If you do not have a standard wall plate, you can mount the Base Unit directly on a wall.

Mounting Directly on a Wall

1.Carefully select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall.

2.Insert the two mounting screws 35¤16 inches apart vertically, allowing about 1¤5 of an inch between the wall and screw heads for mounting the phone. Make sure the screws are securely fastened, and that the wall material is capable of supporting the weight of the Base Unit; otherwise, damage to the Base Unit could result.

3.Plug one end of the Telephone Line Cord (supplied) into the “LINE IN” jack on the Base Unit. Lay the cord inside the molding on the Wall Mount Adapter connected to the Base Unit.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Table of Contents Important Safety Instructions Page Unpacking About Your EXPFCC Requirements EXP 9100 Features Automatic Digital Code SecurityAuto Channel Scan and Auto Channel Change Auto Power ControlSpread Spectrum Technology Selecting the Installation Location Installing Your EXPConnecting the Telephone Line Installing the Base Unit on a Desk or Tabletop Setting the Handset Retainer Installing the Wall-Mount Adapter on the Base UnitMounting the Base Unit on a Wall Mounting on a Standard Wall Plate Mounting Directly on a WallInstalling the Battery Pack BT-9100 Charging the Handset’s Battery Pack Charging Extra Battery PacksLow Battery Indicator Base Unit Battery Back-Up FeatureCleaning the Battery Contacts Using Your EXP Preparing the Base Unit and HandsetMaking a Call Answering a CallDialing a Stored Number Special Features Press Using Your EXP 9100 MemoryStoring a Number Storing a One-Touch Dialing NumberErasing a Stored Number Using your EXP 9100 IntercomStoring Mixed Tone/Pulse numbers Paging from the Base UnitPaging from the Handset to the Base Unit Using the EXP 9100 as a Room MonitorPaging the Base Unit While a Call is Holding To turn Room Monitoring onTroubleshooting Problem SuggestionRange Telephone Line ProblemsImportant Electrical Considerations Radio InterferenceBase Unit SpecificationsHandset EXP Precautions Nickel-Cadmium Battery DisposalOne Year Limited Warranty ZUDUD01304AZ Base Unit Controls & Functions Handset Controls & Functions
Top Page Image Contents