If the Base Unit loses power while the Handset is off the Base, the Digital Code may be erased. When this happens, the Handset will not function. To restore the Digital Code:
1.Remove the Handset from the Base Unit (if it is on the Base Unit).
2.Restore power to the Base Unit.
3.Place the Handset back on the Base Unit.
The CHARGE LED will blink twice to indicate that the Digital Security Code is set.
NOTE: It may take up to 5 seconds to establish contact between the Handset and Base Unit and reset the Digital Security Code.
Auto Channel Scan and Auto Channel Change
During a call, your EXP 9100 constantly monitors the noise level of the channel. If the channel becomes too noisy, the unit automatically switches to a clearer channel to maintain the best transmission quality.
Spread Spectrum Technology
Your EXP 9100 uses Spread Spectrum Technology which provides a digital link between the Base Unit and Handset. This advancement results in unparalleled security, virtually eliminating any chance of outside monitoring, and greatly improves noise reduction for
Auto Power Control
The EXP 9100 automatically sets the Handset RF power level, depending on the distance from the Base Unit. When the Handset is near the Base Unit, the RF power level is low. When the Handset is at a greater distance from the Base Unit, the RF power level is set automatically to high. This provides the clearest possible communications while making the most efficient use of the battery power.
6