Getting Started
Re : Handsets can answer calls from any port or line, unless port is dedicated to a specific handset or group.
1.Handset Registration.
a.Press REG button on Base “00” (default), four LEDs will light up in setting mode.
b.Handset operation: Press MENU
6 
1 . (It will complete the registration process).
c.Repeat, as needed, to add handsets.
2.Establishing additional Base Units:
a.Press REG button on new Base.
b.Use Handset 10 or 11 to Add base :
Press MENU
8 
1 .
c.Enter 01~07 (Base ID).
d.Repeat, as needed, to add base units.
10
Select Mode 1.Add Base
10
Added Base Number: **
CANCEL
Notes:
1.Only Handset 10, 11 can assign Base ID.
2.Base“00” is a primary base. All handset must register only on Base “00”.
3.To avoid interference, the interval between any two bases should be at least 10 meters (about 30 feet).
Handset and Charger Installation
1.Plug the transformer end of the Charger AC/DC adaptor into a standard AC electric power outlet, plug the other end into the “DC In” jack on the back of the Charger.
2.Install battery pack onto the handset.
3.Install handset antenna.
4.Place handset onto the charger front slot.
5.The phone system is now ready to perform basic functions such as making and receiving phone calls and intercom calls. No base station handset programming is needed for basic operations.
29