EnGenius Technologies DURAWALKIE user manual Change System and Line Settings by Administrator

Advanced Operations

Change System and Line Settings by Administrator

1.There are two system parameters that can be changed by the administrator: clear (de-register) handset ID and set the next handset ID to be assigned by the base.

2.From an administrator handset (Handset 10 or 11), press MENU (Right softkey).

3.Press number 9 , this will enter the administration menu.

4.Press number 1 , handset enters System setting menu.

a.Dial tone:

Press 1 to set up the dial tone to be either “Tone” or “Pulse” . Press

1to choose “Tone” or press 2 to choose “Pulse”.

b.Flash time:

Press 2 to set up the flash time from 100ms, 200ms, to 900ms (9 levels to choose from.) For example, press 2 if the desired flash time is 200ms. Default flash is 600ms.

c.Line Detect:

Press 3 to set up the line detect to be either “On” or “Off” Press 1 to choose “On” or press 2 to choose “OFF”. Default is ON .

d.Clear Handset ID:

Press 4 and enter a two-digit Handset ID when prompted to clear this ID for later assignment.

e.Set next Handset ID to be assigned:

Press 5 and enter a two-digit Handset ID when prompted. This is the ID that will be given out by the base to the next handset registering with the base.

5.Press number 2 , handset enters Line Setting menu.

a.Enter Base ID(00~07) to access base.

b.Press 1 to enter Broadcast setting.

i.Press or to select L3 or L4 (the status of setting will be displayed on LCD)

ii.Press CHANGE to enter the setting mode, and the base ID will be displayed on LCD.

iii.Press ON (Left softkey) to enable the broadcast function. Press OFF (Right softkey) to disable the broadcast function.

51