TG2421AL_2422AL(e).book Page 32 Tuesday, March 15, 2005 6:29 PM
Programmable Settings
Display options
Handset LCD contrast
You can adjust the handset display contrast. There are 6 levels. The default setting is level 3.
1 Press {MENU}.
2 Scroll to “Initial setting” by pressing {V} or {^}, then press {>}.
3 Scroll to “LCD contrast” by pressing {V} or {^}, then press {>}.
4 Press {V} or {^} repeatedly to select the desired setting.
5 Press {Save}, then press {OFF}.
Telephone settings
Recall time
The recall time depends on your telephone exchange or host PBX.
You can select: “90ms” (milliseconds), “100ms” (default), “110ms”, “250ms”, “300ms”, “400ms”, “600ms”, or “700ms”.
1
2 Scroll to “Initial setting” by pressing {V} or {^}, then press {>}.
3 Scroll to “Set tel line” by pressing {V} or {^}, then press {>}.
4 Scroll to “Set recall time” by pressing {V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select the desired setting.
6 Press {Save}, then press {OFF}.
Note:
LYou can access Telstra’s “EASY CALL” service by having the recall time set at 100 ms, and then follow Telstra’s “EASY CALL” instructions to operate this service.
LIf the unit is connected via a PBX, certain PBX functions (call transferring, etc.) may not work correctly. Consult your PBX supplier for the correct setting.
Line mode
The line mode is preset to “B” and generally should not be adjusted. If “Line in use” on the handset is not displayed properly, the line mode selection is incorrect. Set line mode to “A”.
1 Press {MENU}.
2 Scroll to “Initial setting” by pressing {V} or {^}, then press {>}.
32