Useful Information
Error messages
Display message
Busy
Check tel line 1
Check tel line 2
Error!!
Failed
Incomplete
Memory full
Messages full
No link to base. Reconnect AC adaptor.
Use rechargeable battery.
You must first subscribe to Caller ID.
Cause/solution
R The called unit is in use.
R Other units are in use and the system is busy. Try again later. R Privacy mode is on for the call you tried to join (page 17).
R The handset you are using is too far from the base unit. Move closer and try again.
R The supplied telephone line cord has not been connected yet or not connected properly. Check the connections (page 8).
R If you use the unit as a
To erase “Check tel line 1”, press MMENUN. a #189 To erase “Check tel line 2”, press MMENUN. a #190 When a power failure occurs, the message is displayed again.
Erase again as above.
R Recording was too short. Try again.
R Phonebook copy failed (page 25). Confirm the other unit (the receiver) is in standby mode and try again.
R Phonebook copy is incomplete. The receiver’s phonebook memory is full. Erase the unwanted phonebook entries (page 24) from the other unit (the receiver) and try again.
R The phonebook memory is full. Erase unwanted entries (page 24). R Message memory is full. Erase unwanted messages (page 36,
37).
R Message memory is full. Erase unwanted messages (page 36, 37).
R The handset has lost communication with the base unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
R A wrong type of battery such as Alkaline or Manganese was inserted. Use only the rechargeable
R You must subscribe to a Caller ID service. Once you receive caller information after subscribing to a Caller ID service, this message will not be displayed.
For assistance, please visit http://www.panasonic.com/help | 45 |