Cisco Systems ATA 186, ATA 188 manual OpFlags, TftpURL, DHCP, VLANSetting

Chapter 5 Parameters and Defaults

Operational Parameters

Table 5-5	ConnectMode Parameter Bit Definitions (continued)
Bit Number		Definition
16		0/1—Disable check-bearer capability in the received Q.931 Setup message.
		If this setting is enabled, the Cisco ATA returns the value 65 as the release-complete cause if the
		Information Transfer Capability (ITC) is “unrestricted digital information” or “restricted digital
		information.” The Cisco ATA returns the value 100 as the release-complete cause if the ITC is
		“unrestricted digital information with tones/announcements” or "video."
		Default: 0
17—18		Not used for H.323.
19		0—Disable sending ringback tone to the caller.
		1—Enable sending ringback tone to the caller.
		Default: 0
20-22		Not used by H.323.
23		0/1—Disable/enable user-configurable setting for call-waiting default.
		If this value is 0 (default), the end user cannot configure the permanent default call-waiting setting for
		every call. Instead, the service provider's default call-waiting setting is used for every call.
		If this value is 1, the end-user can configure the permanent default call-waiting setting for every call, thus
		overriding the value set by the service provider.
		Default: 0
24		0/1—Disable/enable the mixing of audio and call waiting tone during a call.
		Default: 0
25 to 31		Reserved.

OpFlags

Description

This parameter enables/disables various operational features.

See Table 5-6 on page 5-35for bit definitions of this parameter.

Value Type

Bitmap

Default 0x2

Voice Configuration Menu Access Code 323

Related Parameters

•TftpURL, page 5-5

•DHCP, page 5-8

•VLANSetting, page 5-12

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for H.323 (version 3.0)

5-34 OL-4804-01