Chapter 5 Parameters and Defaults
Tone Configuration Parameters
Two examples of Extended Format B, both using the Reorder tone, follow.
ReorderTone Parameter Example1
Assume that you want a reorder tone in which:
•The frequencies 900 Hz, 1400 Hz, and 1800 Hz play sequentially.
•Each frequency plays once for 0.33 seconds.
•There is no silence after the first and the second frequencies.
•There is 1 second of silence after the third frequency (before the first frequency starts again)
•The volume of each frequency is
•The tone plays until another call event stops the tone.
For this reorder tone, make the following setting. See Table
ReorderTone:101,3,24917,3405,14876,4671,5126,5178,3,2640,0,2640,0,
2640,8000,0,0
Table
Component | Setting | Explanation |
|
|
|
Sequential | 101 | Frequencies play sequentially |
|
|
|
NumOfFreqs | 3 | Three frequencies in the tone |
|
|
|
TFreq1 | 24917 | First frequency is 900 Hz |
|
|
|
TAmpl1 | 3405 | First frequency volume is |
|
|
|
TFreq2 | 14876 | Second frequency is 1400 Hz |
|
|
|
TAmp2 | 4671 | Second frequency volume is |
|
|
|
TFreq3 | 5126 | Third frequency is 1800 Hz |
|
|
|
TAmp3 | 5178 | Third frequency volume is |
|
|
|
NumOfOnOffPairs | 3 | Three |
|
|
|
OnTime1 | 2640 | Sound in first |
|
| seconds |
|
|
|
OffTime | 0 | No silence after the first sound (the second |
|
| sound plays immediately) |
|
|
|
OnTime2 | 2640 | Sound in second |
|
| seconds |
|
|
|
OffTime2 | 0 | No silence after the second sound (the third |
|
| sound plays immediately) |
|
|
|
OnTime3 | 2640 | Sound in third |
|
| seconds |
|
|
|
OffTime3 | 8000 | 1 second of silence after the sound in the third |
|
| |
|
| beginning with the first |
|
|
|
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for H.323 (version 3.0)
| ||
|