Uniden UH-057 manual Getting Started Antenna, Battery Information

Page 15

Getting Started

Antenna

To attach the antenna to the TNC connector on top of your radio, press down and rotate the antenna base clockwise until it seats firmly into place.

Battery Information

The Sundowner UH-O57 comes with a standard recharge- able Ni-Cd Battery Pack. An optional heavy duty recharge- able Ni-Cd Battery Pack is also available.

Installation

THE RECHARGEABLE NICKEL-CADMIUM BATTERY PACK MUST BE CHARGED FULLY BEFORE USING IT FOR THE FIRST TIME.

When installing or removing the rechargeable Battery Pack,

be sure that the power (ON/OFF Volume control) is turned OFF.

To remove the Battery Pack, push up on the release button and slide the Battery Pack away from the radio.

To replace, align the Battery Pack rails with the transceiver and slide toward the transceiver unit until the Battery Pack locks in place.

Page 13

UH-O57

Image 15

Contents UnidenSUNDOWN ERUH-57 Uniden~ is a registered trademark of Uniden Corporation Nickel-Cadmium Battery WarningTable of Contents Selcall Descrl ptlon Ulrements3UH-O57 Feature Highlights UH-O5J UH-O57 Belt Clip Wrist strapLocks out a selected channel from channel scan Top Indicators and Display~~88 Side Controls and Connectors TX Power HI/LOW Switch -Press to set the TransmitAC Adaptor/Charger Jack Connect AC Adaptor/Charger here Built-in Speaker Audio Output Front ControlsRX ID, TX ID, or lead-In tone Enter lead-In Delay ProgrammingUH-O57 Hash Key Press and hold for 1.5 sec toChannel Enter Key Press to enter the selectedGetting Started Antenna Battery InformationBelt Clip Installation Recharging the Nickel-Cadmium Battery PackOperation To resume scanning, press the 0 Key Channel ScanPress D PriorityScanning is inactive in TSO Scan ModeCreate a Channel Scan List with Channel Lock-Out Feature Transmit Maximum transmit power output level of UH-O57is 5 wattsLow Battery Level Detection Button. DUP indicator appears on the LCD DisplayDisplay Special Feature Puts the receiver on Quiet Mode also known as Tone Required Selcallid to open the Quiet condition is receivedExample Choosing CH20 as your Call Channel Tone Squelch Scanning When a call is receivedKey Cancel TSQ Scanning by pressing either the 0 orUsing the 0 or 0 Key, browse through the TSQ Channels When a Selcall is received, press the PIT SwitchTone Calling TX Selcall ID FormatRadios 3 4 D CD 1 ADJReceiver Selcall ID Press the @ Key Transmitter Selcall IDTcAL ProgrammingMSec Other SELCALLParametersLead-In Delay Lead-In Tone Key LCD DisplaySec To remove the lead-In Tone Select the lead-In Tone you want to use ExampleProgramming Guide Delay SPage35UH-O57 Care and MaintenancePrincess Highway, Rockdale, NSW ServiceUHF CB Channel Information Duplex Operating Mode Simplex Operating ModeButtons ChannelsTransm itter Warranty UTZZO1857ZZ