Uniden UH-057 manual CD 1, Adj, Receiver Selcall ID

Page 29

Programming

Since UH-O57 can support either 5 tone or 6 tone signalling format, you and your group must decide which format are you going to use.

Receiver SELCALL ID

To program your own receiver SELCALL ID, do the follow- ing procedure.

1.Press and hold the @ Key for about 1.5 seconds. Two beeps will be heard and the LCD displ~ys:

[ - -]

2.Press the @ Key. The TSQ indicator appears on the LCD Display. Flashing.

" , ,	GIlD -
q~:-
, I '

3.Enter your chosen SELCALL ID using the Numeric Keypad.

Example: 1 2345

Every time you press the Numeric Keypad confirmation tones will be heard. The SELCALL Tone assigned to the pressed Key will be displayed on the LCD as shown: (please see page 34 for the Numeric Key SELCALL TONE assignment)

CD 1 -II

CD 1 -2]

<D r - 31

<D t aDJ

CD 1: S1

Page 27

UH-O57

Image 29

Contents UnidenSUNDOWN ERUH-57 Uniden~ is a registered trademark of Uniden Corporation Nickel-Cadmium Battery WarningTable of Contents Selcall 3UH-O57 Descrl ptlonUlrements Feature Highlights UH-O5J UH-O57 Belt Clip Wrist strapLocks out a selected channel from channel scan Top Indicators and Display~~88 AC Adaptor/Charger Jack Connect AC Adaptor/Charger here Side Controls and ConnectorsTX Power HI/LOW Switch -Press to set the Transmit Built-in Speaker Audio Output Front ControlsUH-O57 Enter lead-In Delay ProgrammingHash Key Press and hold for 1.5 sec to RX ID, TX ID, or lead-In toneChannel Enter Key Press to enter the selectedGetting Started Antenna Battery InformationBelt Clip Installation Recharging the Nickel-Cadmium Battery PackOperation To resume scanning, press the 0 Key Channel ScanPress D PriorityScanning is inactive in TSO Scan ModeCreate a Channel Scan List with Channel Lock-Out Feature Transmit Maximum transmit power output level of UH-O57is 5 wattsDisplay Low Battery Level DetectionButton. DUP indicator appears on the LCD Display Special Feature Example Choosing CH20 as your Call Channel Puts the receiver on Quiet Mode also known as ToneRequired Selcallid to open the Quiet condition is received Tone Squelch Scanning When a call is receivedUsing the 0 or 0 Key, browse through the TSQ Channels Cancel TSQ Scanning by pressing either the 0 orWhen a Selcall is received, press the PIT Switch KeyRadios Tone CallingTX Selcall ID Format 3 4 D Receiver Selcall ID CD 1ADJ Press the @ Key Transmitter Selcall IDTcAL ProgrammingMSec Other SELCALLParametersLead-In Delay Sec Lead-In ToneKey LCD Display To remove the lead-In Tone Select the lead-In Tone you want to use ExampleProgramming Guide Delay SPage35UH-O57 Care and MaintenancePrincess Highway, Rockdale, NSW ServiceUHF CB Channel Information Duplex Operating Mode Simplex Operating ModeButtons ChannelsTransm itter Warranty UTZZO1857ZZ