Uniden UH-057 manual Service, Princess Highway, Rockdale, NSW

Page 38

Service

Should you find it desirable or necessary to have service performed on your Uniden Sundowner UH-O57, you are urged to contact the Uniden Dealer from whom you made your purchase. Your Uniden Dealer will be able to assist you with complete service information.

If you require service that is within the terms of your warranty, you should present a copy of your receipt to your dealer to authenticate your claim.

If you find it inconvenient to obtain service assistance from your dealer, you may obtain service from Uoiden Service Division. If you want this service, please pack your radio in a suitable container that will provide adequate protection. Enclose a note describing the problem and a copy of your

receipt and send the radio (transportation prepaid) to:

- ~

un.den Australia Pty. Limited

SERVICE DIVISION

345Princess Highway, Rockdale, NSW 2216

UH-O57

Page 36

Page 37 Page 39
Image 38
Page 37 Page 39
Contents UnidenSUNDOWN ERUH-57 Nickel-Cadmium Battery Warning Uniden~ is a registered trademark of Uniden CorporationTable of Contents Selcall 3UH-O57 Descrl ptlonUlrements Feature Highlights UH-O5J Belt Clip Wrist strap UH-O57Top Indicators and Display Locks out a selected channel from channel scan~~88 AC Adaptor/Charger Jack Connect AC Adaptor/Charger here Side Controls and ConnectorsTX Power HI/LOW Switch -Press to set the Transmit Front Controls Built-in Speaker Audio OutputHash Key Press and hold for 1.5 sec to Enter lead-In Delay ProgrammingUH-O57 RX ID, TX ID, or lead-In toneEnter Key Press to enter the selected ChannelBattery Information Getting Started AntennaRecharging the Nickel-Cadmium Battery Pack Belt Clip InstallationOperation Channel Scan To resume scanning, press the 0 KeyPriorityScanning is inactive in TSO Scan Mode Press DCreate a Channel Scan List with Channel Lock-Out Feature Maximum transmit power output level of UH-O57is 5 watts TransmitDisplay Low Battery Level DetectionButton. DUP indicator appears on the LCD Display Special Feature Example Choosing CH20 as your Call Channel Puts the receiver on Quiet Mode also known as ToneRequired Selcallid to open the Quiet condition is received When a call is received Tone Squelch ScanningWhen a Selcall is received, press the PIT Switch Cancel TSQ Scanning by pressing either the 0 orUsing the 0 or 0 Key, browse through the TSQ Channels KeyRadios Tone CallingTX Selcall ID Format 3 4 D Receiver Selcall ID CD 1ADJ Transmitter Selcall ID Press the @ KeyProgramming TcALOther SELCALLParameters MSecLead-In Delay Sec Lead-In ToneKey LCD Display Select the lead-In Tone you want to use Example To remove the lead-In ToneDelay S Programming GuideCare and Maintenance Page35UH-O57Service Princess Highway, Rockdale, NSWUHF CB Channel Information Simplex Operating Mode Duplex Operating ModeChannels ButtonsTransm itter Warranty UTZZO1857ZZ
Top Page Image Contents