Uniden UH-057 manual Nickel-Cadmium Battery Warning

Page 2

_

Please read this Operating Guide carefullybefore operating this radio

Safety Information

DO NOT operate the transmitter of any radio equip- ment with the antenna touching, or close to the eyes, face, or exposed body parts.

DO NOTlet children operate any transmitter-equipped radio equipment.

DO NOToperate the transmitter of any radio equip- ment unless all the Radio Frequency (RF) connectors

are secure and any open connectors are properly terminated.

Have your radio equipment serviced by a qualified technician.

Nickel-Cadmium Battery Warning

This equipment contains a Nickel-Cadmium battery.

The Nickel-Cadmium battery contained in this equip- ment may explode if disposed of in a fire.

DO NOTshort circuitthe battery.

DO NOTcharge the Nickel-Cadmiumbattery used in this equipment in any other charger other than the one designed to charge this battery. Using another charger may damage the battery, or cause the battery to explode.

Uniden~ is a registered trademark of Uniden Corporation.

Features, Specifications, and availability of Optional Accessories are all subject to change without notice.

Image 2
Contents UnidenSUNDOWN ERUH-57 Nickel-Cadmium Battery Warning Uniden~ is a registered trademark of Uniden CorporationTable of Contents Selcall 3UH-O57 Descrl ptlonUlrements Feature Highlights UH-O5J Belt Clip Wrist strap UH-O57Top Indicators and Display Locks out a selected channel from channel scan~~88 AC Adaptor/Charger Jack Connect AC Adaptor/Charger here Side Controls and ConnectorsTX Power HI/LOW Switch -Press to set the Transmit Front Controls Built-in Speaker Audio OutputHash Key Press and hold for 1.5 sec to Enter lead-In Delay ProgrammingUH-O57 RX ID, TX ID, or lead-In toneEnter Key Press to enter the selected ChannelBattery Information Getting Started AntennaRecharging the Nickel-Cadmium Battery Pack Belt Clip InstallationOperation Channel Scan To resume scanning, press the 0 KeyPriorityScanning is inactive in TSO Scan Mode Press DCreate a Channel Scan List with Channel Lock-Out Feature Maximum transmit power output level of UH-O57is 5 watts TransmitDisplay Low Battery Level DetectionButton. DUP indicator appears on the LCD Display Special Feature Example Choosing CH20 as your Call Channel Puts the receiver on Quiet Mode also known as ToneRequired Selcallid to open the Quiet condition is received When a call is received Tone Squelch ScanningWhen a Selcall is received, press the PIT Switch Cancel TSQ Scanning by pressing either the 0 orUsing the 0 or 0 Key, browse through the TSQ Channels KeyRadios Tone CallingTX Selcall ID Format 3 4 D Receiver Selcall ID CD 1ADJ Transmitter Selcall ID Press the @ KeyProgramming TcALOther SELCALLParameters MSecLead-In Delay Sec Lead-In ToneKey LCD Display Select the lead-In Tone you want to use Example To remove the lead-In ToneDelay S Programming GuideCare and Maintenance Page35UH-O57Service Princess Highway, Rockdale, NSWUHF CB Channel Information Simplex Operating Mode Duplex Operating ModeChannels ButtonsTransm itter Warranty UTZZO1857ZZ