Uniden UH-057 manual UH-O5J

Page 7

.

.

.

.

.

.

.

Receiver Quieting (Tone Squelch)

Prevents any unwanted signal inthe channel from

being heard unless the required tone codes to open the "QuietCondition"is received.

CALLAlarm

When selectivelycalled, emits an audible alarm to notifythe user that a caller is on the channel.

Acknowledge Tone

Sends a response tone automaticallyto the caller to acknowledge a Selective Call.

Group Call

Capable of transmittingand responding to group calls.

Direct Channel Keying

Gives the user option to select channels directly using the Numeric Keypad.

Rechargeable Battery Pack

Eliminatesthe costly expense of frequent Battery replacement.

Battery Free Memory

The programmed channels on the Scan list and

other unitsettings are retained in memory when the BatteryPack is removed fromthe unit.

Page 5

UH-O5J

Image 7
Contents UnidenSUNDOWN ERUH-57 Uniden~ is a registered trademark of Uniden Corporation Nickel-Cadmium Battery WarningTable of Contents Selcall Ulrements Descrl ptlon3UH-O57 Feature Highlights UH-O5J UH-O57 Belt Clip Wrist strapLocks out a selected channel from channel scan Top Indicators and Display~~88 TX Power HI/LOW Switch -Press to set the Transmit Side Controls and ConnectorsAC Adaptor/Charger Jack Connect AC Adaptor/Charger here Built-in Speaker Audio Output Front ControlsRX ID, TX ID, or lead-In tone Enter lead-In Delay ProgrammingUH-O57 Hash Key Press and hold for 1.5 sec toChannel Enter Key Press to enter the selectedGetting Started Antenna Battery InformationBelt Clip Installation Recharging the Nickel-Cadmium Battery PackOperation To resume scanning, press the 0 Key Channel ScanPress D PriorityScanning is inactive in TSO Scan ModeCreate a Channel Scan List with Channel Lock-Out Feature Transmit Maximum transmit power output level of UH-O57is 5 wattsButton. DUP indicator appears on the LCD Display Low Battery Level DetectionDisplay Special Feature Required Selcallid to open the Quiet condition is received Puts the receiver on Quiet Mode also known as ToneExample Choosing CH20 as your Call Channel Tone Squelch Scanning When a call is receivedKey Cancel TSQ Scanning by pressing either the 0 orUsing the 0 or 0 Key, browse through the TSQ Channels When a Selcall is received, press the PIT SwitchTX Selcall ID Format Tone CallingRadios 3 4 D ADJ CD 1Receiver Selcall ID Press the @ Key Transmitter Selcall IDTcAL ProgrammingMSec Other SELCALLParametersLead-In Delay Key LCD Display Lead-In ToneSec To remove the lead-In Tone Select the lead-In Tone you want to use ExampleProgramming Guide Delay SPage35UH-O57 Care and MaintenancePrincess Highway, Rockdale, NSW ServiceUHF CB Channel Information Duplex Operating Mode Simplex Operating ModeButtons ChannelsTransm itter Warranty UTZZO1857ZZ