EFJohnson 7243 LTR-Net Portable UHF manual Recalling Numbers From Memory, Exiting Dial Mode

Page 38

DIAL MODE

NOTE: The character is stored and sent normally (no pause occurs), and the # character should not be stored because it may terminate the call when it is sent.

Recalling Numbers From Memory

From Specific Location - FCN RCL 0-9 (location number)

Stored in Next Location - RCL (hold down to repeat). If a number is already displayed, the number in the next higher location is indicated; if display is blank, the number in location 1 is indicated first.

Last Number Dialed by Recalling from Memory - FCN RCL

Last Number Dialed - FCN RCL

Exiting Dial Mode

Without Sending Call Termination Characters - To exit the dial mode without sending the call termination characters, press FCN DIAL.

Sending Call Termination Characters - To exit the dial mode and send the characters which automatically terminate the call, press FCN PHONE. Terminating a call in this manner prevents any additional billing for the time required to automatically detect the end of a call.

Placing Calls Without Selecting Dial Mode

Telephone and Auxiliary calls can also be placed without selecting the dial mode by using the procedure which follows:

1.Access the radio system by briefly pressing the PTT switch.

2.When a dial tone is heard, dial the desired number while pressing the PTT switch. If too much time elapses between digits, the call is automatically terminated.

NOTE: When receiving telephone or auxiliary calls, the selection of the dial mode is optional because it does not enhance operation.

39

Image 38

Contents Operating Manual Page Safety Training Information Electromagnetic Interference/Usage Compatibility Table of Contents Table of Contents Table of Contents Quick Reference Guide BusyFeatures General FeaturesControls and Display Top Panel ControlsSide Controls Busy UID DisplayControls and Display Front Panel Keys FCN ScanSYS RCL Dial Standard Mode A/D Standard Mode SYS System/Group Display Mode Power-Up SequenceSetting Volume Levels Basic OperationNumeric Display Mode System and Group SelectKeypad Disable Transceiver LockLTR-Net, LTR, and Conventional Operation Low Battery IndicationOption Switches Basic Operation Bank Select General FeaturesCall Indicator Receive-Only Groups Home System/Group SelectProceed Clear-To-Talk Tone Tone Select Time-Out TimerStandard Group Calls GeneralPlacing a Standard Group Call LTR-Net and LTR OperationConventional Operation Receiving a Standard Group CallTelephone Calls Placing Telephone CallsReceiving a Telephone Call Placing LTR-Net Auxiliary Calls LTR-NET Auxiliary CallsLandside-Originate Telephone Calls Receiving Auxiliary Calls Option Switches and Menu Mode Menu Mode and Option Switch FunctionsMenu Mode IntroductionMenu Mode Flowchart Introduction Dial ModeSelecting Dial Mode Storing Numbers in Memory Dialing a NumberSending the Number Recalling Numbers From Memory Exiting Dial ModePlacing Calls Without Selecting Dial Mode System and Group Scanning System and Group Scanning Scan List Programming Transmitting In The Scan Mode Scan Delay and Continue TimersSystem and Group Scanning Priority Calls LTR-NET and LTR FeaturesTransmit Inhibit LTR-Net Special Calls LTR-NET FeaturesLTR-Net Standard Calls Busy QueuingRoaming Squelch Adjust LTR FeaturesConventional Features Standard Group CallsMonitoring Before Transmitting Monitor Mode Selected Transmit Disable On BusyTalk-Around Call Guard SquelchMiscellaneous Supervisory TonesLTR-Net Special Call Tones LTR Telephone Call Tones Display MessagesMiscellaneous Menu Mode Messages Bank SEL Bank selectRechargeable Battery Pack Alpha NumericMiscellaneous Battery Charger Operation Operation At Extended Range Charger IndicatorsSpeaking Into Microphone Licensing Transceiver ServiceIndex Busy 14 Call 13 Index 002-7200-600