Cobra Electronics MR HH415LI VP EU Maintenance, Troubleshooting, Press Backlight, Key Lock button

Page 59

Operating Your Radio

Maintenance and Troubleshooting

Maintenance

Very little maintenance is required to keep your CobraMarine VHF radio in good operating condition:

Keep the radio and charger clean by wiping with a soft cloth and mild detergent. Do not use solvents or harsh or abrasive cleaners, which could damage the case or scratch the LCD screen.

If the radio is exposed to salt water, wipe with a soft, moist cloth at least once a day to prevent buildup of salt deposits, which could interfere with button operation.

If the radio will be stored for a long period, such as over the winter, remove the batteries from the battery tray and store them in a separate package. This is especially important if you are using alkaline batteries.

Troubleshooting

 

 

 

 

 

 

Problem

Possible Cause(s)

Solution(s)

 

 

 

No display on LCD when

Batteries are exhausted

Recharge or

radio is turned On

 

replace batteries

 

Batteries not installed

Remove batteries and

 

properly

reinstall according to

 

 

polarity markings

 

 

 

LiON batteries run

Batteries are at the

Replace with new

down quickly

end of their life

batteries

 

 

 

Will transmit at

Batteries are low

Recharge or

one (1) or three (3) watts,

 

replace batteries

but not at five (5) watts

Selected channel is imited

Switch to

 

 

to one (1) watt

another channel

 

 

 

Will not transmit

Selected channel is

Switch to

 

limited to receive only

another channel

 

 

 

No sound from speaker

Volume level is too low or

Re-adjust volume

 

squelch level is too deep

and squelch

 

 

 

No response to

Button lock is On

Press Backlight/

button press

 

Key Lock button

 

 

 

No answer to calls

Out of range of

Switch to three (3) or five

 

other station

(5) watts or move closer

 

Signal is blocked

Move until you have a “line-

 

by terrain

of-sight” to the other station

 

 

 

54 English

Image 59
Contents MR HH415LI VP EU Our Thanks to You and Customer Assistance LCD Radio Controls and IndicatorsBacklit LCD Screen and Product Features Speaker/Mic Jack Product FeaturesTable of Contents Important Safety Information Important Safety InformationGeneral Precautions Important Safety Information Recommendations for Marine Communication Recommendations for Marine CommunicationRadio Call Sign Licensing InformationStation License Canadian or U.S.A. Station LicenseVHF Marine Radio Procedures Vessel Corsair calling the vessel Vagabond Voice CallingVoice Calling Radiotelephone Calls Radiotelephone CallsEmergency Messages and Distress Procedure Emergency Messages and Distress ProcedureIf You Hear a Distress Call Marine Emergency SignalsEnd message by saying Marine Distress ProcedureTell where you are SayFor Example VHF Marine Channel Assignments Digital Selective Calling Public Correspondence marine operatorPort Operations NavigationalUSA 03A Government Only International Distress, Safety and Calling156.900 61A U.S. Government Only Canada Coastguard Only 21A U.S. Government Only Canada Coastguard Only23A Government Only Channel Digital Selective Calling Voice communications not allowed 64A U.S. Government Only Canada Commercial FishingLimits 81A U.S. Government Only Environmental Protection Operations Included in this Package Included in this PackageBelt Clip Antenna InstallationAntenna, Wrist Strap and Belt Clip Wrist StrapBatteries and Charger Installing the Battery PackBatteries and Charger Initial Charge Alkaline Batteries To Remove Battery Pack from RadioMaintaining the Battery Charge Common Radio Functions Power/Volume/Squelch Controls Power On/Off ControlVolume Control Getting StartedTalk Button Squelch ControlKey Lock TRI-WATCH Button Call/Enter/Setup Button Preset ButtonBacklight/Key Lock Button To Display the Backlight MomentarilyScan Button Call /Enter/Setup Button High/Medium/Low H-M-L Power ButtonTo Toggle Between H-M-L Power Modes To Set Personal Default Settings To Set Channel Map Operating Area Setup Mode ProgrammingSetup Mode Programming International/Canada/USA Channel MapsTo set VibrAlert VibrAlert ModeTo Set Call Tone Call Tone ModeTo Set Key Tone On or Off Roger Beep ModeKey Tone Mode To Set Roger Beep On or OffTo Set the Atis ID Number Atis ID ProgrammingAtis ID Programming Atis ID Programming Standby/Receive and Transmit Marine Standby and Receive Rx ModeTo Transmit a Message Transmit Tx ModeStandby/Receive Transmit Advanced Operation Channel 16 ModeTo Switch to Channel Advanced OperationTri-Watch Setup To Program or Edit the Tri-Watch Channels Tri-Watch ModeTri-Watchmemory channels Using Tri-Watch Tri-Watch Scan ModeTo Program Memory Locations Memory Location ModeTo Erase Stored Memory Locations To Exit Memory Location ModeTo Recall a Stored Memory Location To Enter Channel Scan Channel Scan ModeMemory Location Scan Mode From Marine Standby mode, press the MEM/ESC button To Enter Memory Location ScanExample Rewind-Say-Again FeatureUsing Rewind-Say-Again Using Rewind-Say-Again to Record Audio Transmission Key Lock button MaintenanceTroubleshooting Press BacklightSpecifications SpecificationsEnglish Lapel Speaker/Microphone AccessoriesAccessories Declaration of Conformity and CE Marking