Pioneer AVH-P4100DVD Installation using the screw holes on the side of the unit

Page 14

Installation

Note

Check all connections and systems before final installation.

Do not use unauthorized parts. The use of unauthorized parts may cause malfunctions.

Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle.

Do not install this unit where:

it may interfere with operation of the vehicle.

it may cause injury to a passenger as a result of a sudden stop.

Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle.

The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.

Optimum performance is obtained when the unit is installed at an angle of less than 30°.

To some types of vehicles, this unit cannot be properly installed. In such case, use the optional installation kit (ADT-VA133).

Installation using the screw holes on the side of the unit

Fastening the unit to the factory radio-mounting bracket.

Position the unit so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at 3 or 4 locations on each side.

If the pawl gets in the way, bend it down.

Factory radio mounting bracket

Binding screw or

 

flush surface screw

 

Be sure to use the

 

screws supplied

 

with this unit.

Dashboard or console

 

Note

In some types of vehicles, discrepancy may occur between the unit and the dashboard. If this happens, use the supplied frame to fill the gap.

14

Image 14
Contents AVH-P4100DVD Contents Connecting the units ACC position No ACC position Parts supplied Connecting the power cord Connecting the units When connecting to separately sold power amp LeftRightWhen connecting with supplied USB cable When connecting with optional CD-IU200V cableWhen connecting with a rear view camera Reversed imagesWhen connecting with a multi-channel processor Connecting and installing the optical cable connection box Connect the optical cable and ground lead to the main unitWhen connecting the external video component and the display Fastening the unit to the factory radio-mounting bracket InstallationInstallation using the screw holes on the side of the unit English Table des matières Raccordements des appareilsRaccordements des appareils Raccordements des appareils Position ACC Pas de Position ACCPièces fournies Branchement du cordon d’alimentation Vert/noir Violet/noirRemarque GaucheDroit Raccordement avec le câble USB fourni Raccordement avec le câble optionnel CD-IU200VFournir des images Raccordements à une caméra de reculCaméra capable de Un miroirLors du raccordement d’un processeur multi-canaux Raccordement du câble à fibres optiques Raccordements à un appareil vidéo externe et à un écran Installation à l’aide des perçages sur le côté de l’appareil Français Contenido Conexión de las unidadesConexión de las unidades AdvertenciaNota Posición ACC Sin posición ACCPiezas suministradas Conexión del cable de alimentación Nota IzquierdaDerecha Cuando conecte con el cable USB suministrado Cuando conecte con el cable CD-IU200V opcionalCuando conecte con una cámara de vista trasera La imagen de la pantalla puede aparecer invertidaCuando conecte con un procesador multicanal IP-BUSConexión del cable óptico Cuando conecte el componente externo y la pantalla Instalación Instalación con agujeros de tornillo en el lado de la unidadCRD4377-A/N UC
Related manuals
Manual 116 pages 52.01 Kb