Pioneer AVH-P4100DVD installation manual Connecting the units

Page 3

Connecting the units

WARNING

To avoid the risk of accident and the potential violation of applicable laws, the front DVD or TV (sold separately) feature should never be used while the vehicle is being driven. Also, rear displays should not be in a location where it is a visible distraction to the driver.

In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit’s DVD features should not be used.

CAUTION

PIONEER does not recommend that you install or service your display yourself. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to authorized Pioneer service personnel.

Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.

Do not drill a hole into the engine compartment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insulation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point.

It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving.

Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism.

Do not shorten any leads. If you do, the protection circuit may fail to work properly.

WARNING

LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.

English

3

Image 3
Contents AVH-P4100DVD Contents Connecting the units ACC position No ACC position Parts supplied Connecting the power cord Connecting the units LeftRight When connecting to separately sold power ampWhen connecting with optional CD-IU200V cable When connecting with supplied USB cableReversed images When connecting with a rear view cameraWhen connecting with a multi-channel processor Connect the optical cable and ground lead to the main unit Connecting and installing the optical cable connection boxWhen connecting the external video component and the display Installation Installation using the screw holes on the side of the unitFastening the unit to the factory radio-mounting bracket English Raccordements des appareils Table des matièresRaccordements des appareils Position ACC Pas de Position ACC Raccordements des appareilsPièces fournies Vert/noir Violet/noir Branchement du cordon d’alimentationRemarque GaucheDroit Raccordement avec le câble optionnel CD-IU200V Raccordement avec le câble USB fourniUn miroir Raccordements à une caméra de reculCaméra capable de Fournir des imagesLors du raccordement d’un processeur multi-canaux Raccordement du câble à fibres optiques Raccordements à un appareil vidéo externe et à un écran Installation à l’aide des perçages sur le côté de l’appareil Français Conexión de las unidades ContenidoAdvertencia Conexión de las unidadesPosición ACC Sin posición ACC NotaPiezas suministradas Conexión del cable de alimentación Nota IzquierdaDerecha Cuando conecte con el cable CD-IU200V opcional Cuando conecte con el cable USB suministradoLa imagen de la pantalla puede aparecer invertida Cuando conecte con una cámara de vista traseraIP-BUS Cuando conecte con un procesador multicanalConexión del cable óptico Cuando conecte el componente externo y la pantalla Instalación con agujeros de tornillo en el lado de la unidad InstalaciónCRD4377-A/N UC
Related manuals
Manual 116 pages 52.01 Kb