Mounting Bolts

I I I . I N S T A L L A T I O N

NOTE: Choosing the correct length bolt allows enough bolt-thread to pass through the undercarriage, ensuring enough room for the mounting washer and nut to be installed securely.

6. From under the vehicle, install the mounting washers and nuts to all five (5) mounting bolts and tighten. See figure 10.

NOTE: The holes in the mounting washers are for working around obstructions. Choose the hole that best works in the area you are installing the mounting bolts.

7.Place the L-base cap over the L-base and secure it with the supplied screws. See figure 11. Replace the base shroud for power rotating base models.

8.Reinstall the upper post.

NOTE: When inserting the upper post into the power rotating base, a slight adjustment of the sprocket may be needed to align the insertion hole with the lower post located inside the power rotating base. This can be done by inserting the upper post into the sprocket and moving it until it descends into the power rotating base’s lower post.

9.Reinstall the motor housing and make adjustments as necessary.

The lift is now fully assembled. See figure 12.

2” (50 MM) OR 3” (75 MM)

WASHER

T-BAR

MOUNTING HOLE

MOUNTING WASHER

NUT

Figure 10. Securing The L-Base

www.silverstarlifts.com

SilverBoom 300