I V . O P E R A T I O N
WARNING! Pinch/Crush Hazard! Always keep hands clear of the lifting strap while the SilverBoom is lifting/ lowering a mobility product. The operator of the lift should stand a safe distance away from the mobility product being lifted/lowered to ensure that feet are never positioned under a raised mobility product.
Do not drag the mobility product into position using the lift. If dragging occurs, your mobility product is too far away from the vehicle. To prevent dragging:
∀Release the lifting strap tension then remove the hook
| from the docking device. | Figure 17. Lifting The Mobility product | |
∀ | Correct the position of the mobility product. | ||
| |||
∀ | Attempt the lift again. |
|
MANDATORY! The SilverBoom 300 is designed to lift a maximum weight of 300 lbs (136 kg). Do not exceed this limit.
7.If the mobility product begins to tilt, lower it com- pletely and adjust the docking device by moving the
| using a |
8. | Tighten the |
| has been found (when using a |
9. | Once the mobility product is raised high enough to Figure 18. Securing The |
| fit into the vehicle, stop the lift. See figure 17. |
10.Swing the
11.If installed in a van or SUV, disconnect the hook from the docking device and attach it to the
MANDATORY! Secure the
WARNING! Do not overtighten the strap. Doing so may put excessive strain on the motor, causing the circuit breaker to trip.
NOTE: If installed in a trunk, disconnect the
SilverBoom 300 | www.silverstarlifts.com | 17 |