Pride Mobility INFMANU3210 manual Electrical Wiring Installation, Base Cap Installation

Page 13

I I I . I N S T A L L A T I O N

PHILLIPS HEAD SCREW 10 MM

 

L-BASE CAP

MOTOR HOUSING

 

UPPER POST

 

L-BASE CAP

 

L-BASE

 

T-BAR

Figure 11. L-Base Cap Installation

Figure 12. Fully Assembled Lift (SilverBoom 300 Shown)

ELECTRICAL WIRING INSTALLATION

1.Route the lift’s long power wire (starting at the lift) through the interior of the vehicle until you reach the automobile battery. See figure 13 and 13A. Conceal the wire behind or under the interior panels (there should be existing holes). Be certain that the wire is protected with a rubber grommet when passing it through the metal panels and into the engine compartment. Inside the engine compartment, secure the wire to the firewall and the inner fender with the supplied plastic wire ties. Use care not to cause abrasions to the power wire. It is important to secure the power wire at various points along its run.

2.Insert the red positive (+) lead on the power wire into the spliced end of the red positive (+) battery lead, then crimp the splice to secure the wire.

3.Connect the red positive (+) battery lead to the positive (+) battery terminal and the black negative (-) ground wire to the negative (-) battery terminal.

WARNING! The red positive (+) wire must be connected directly to the positive (+) battery terminal.

WARNING! The black negative (-) wire must be connected directly to the negative (-) battery terminal.

4.Connect the harness extending from the motor housing to the harness coming from the battery (black to black and red to red).

SilverBoom 300

www.silverstarlifts.com

13

Image 13
Contents SilverStar Phone Number Purchase Date Serial Number F E T Y G U I D E L I N E SIII N T E N T SInternet and Private Purchases PURCHASER’S Agreement N T R O D U C T I O NShipping and Delivery Information ExchangeS a F E T Y Product Safety SymbolsS a F E T Y Lifting NON-PRIDE Items Lifting Capabilities InstallationPrelift Inspection Operator PositioningPower Rotating Base Shroud RE- Moval I . InstallationDetermine L-BASE Location Assembling the Lift Trunk Installation Silverboom 300 Manual Rotation onlyTo adjust the height adjustment ring Hatchback INSTALLATION- MINIVANS, Station WAGONS, ETCTo adjust the boom-arm BOOM-ARM AdjustmentBase Installation Tools needed for installationMounting Bolts Base Cap Installation Electrical Wiring InstallationFUSE25-AMP Crimp Here Automobile Battery O P E R a T I O N HAND/REMOTE Control OperationLifting the Mobility Product To replace the batteries of the remote controlUsing a C-arm Manual Lift Strap Operation BOOM-ARM Manual Rotation Models with a Power Rotating BaseTo reset the main circuit breaker TroubleshootingLift will not Operate Lift Stops OperatingTo restore proper lifting strap travel M a I N T E N a N C E S C H E D U L E Perform every 36 months Power Rotating Base onlyPerform prior to daily use Perform every 6 monthsONE-YEAR Warranty THREE-YEAR Transferable Limited WarrantyService Checks and Warranty Service I . W a R R a N T YPage INFMANU3210