Pride Mobility INFMANU3210 manual Manual Lift Strap Operation

Page 18

I V . O P E R A T I O N

12.Disconnect the power to the SilverBoom to prevent any accidental movement when transporting your mobility product.

WARNING! Your SilverBoom was designed to be mounted primarily in a motor vehicle. Mounting your SilverBoom on a platform, where the height of the lift may cause the lifting strap to extend beyond a safe point, can damage the SilverBoom and injure the lift operator.

MANUAL LIFT STRAP OPERATION

The SilverBoom 300 with a power rotating base is equipped with a lift strap manual override that serves as backup in the event of a power failure. Using the sup- plied tool, rotate the manual crank located at the front of the boom-arm motor housing clockwise or counterclock- wise to move the lift strap up or down. See figure 19.

NOTE: Attaching the supplied tool to a power drill will increase the speed at which the lifting strap will move.

BOOM-ARM MANUAL ROTATION (MODELS WITH A POWER ROTATING BASE)

In the event of power failure, the boom-arm can be manu- ally rotated by pulling back the flip handle to disengage the securement pin. See figure 20. This allows the boom- arm to swing freely. To secure the boom-arm, rotate it until the flip handle securement pin “clicks” into the up- per post.

MANUAL OVERRIDE TOOL INSERTION POINT

Figure 19. Lift Strap Manual Override

BOOM-ARM

UPPER POST

FLIP HANDLE

Figure 20. Lift Strap Manual Override

18

www.silverstarlifts.com

SilverBoom 300

Image 18
Contents SilverStar F E T Y G U I D E L I N E S Phone Number Purchase Date Serial NumberN T E N T S IIIShipping and Delivery N T R O D U C T I O NInternet and Private Purchases PURCHASER’S Agreement Information ExchangeProduct Safety Symbols S a F E T YS a F E T Y Prelift Inspection Lifting Capabilities InstallationLifting NON-PRIDE Items Operator PositioningI . Installation Power Rotating Base Shroud RE- MovalDetermine L-BASE Location Trunk Installation Silverboom 300 Manual Rotation only Assembling the LiftHatchback INSTALLATION- MINIVANS, Station WAGONS, ETC To adjust the height adjustment ringBase Installation BOOM-ARM AdjustmentTo adjust the boom-arm Tools needed for installationMounting Bolts Electrical Wiring Installation Base Cap InstallationFUSE25-AMP Crimp Here Automobile Battery HAND/REMOTE Control Operation O P E R a T I O NTo replace the batteries of the remote control Lifting the Mobility ProductUsing a C-arm BOOM-ARM Manual Rotation Models with a Power Rotating Base Manual Lift Strap OperationLift will not Operate TroubleshootingTo reset the main circuit breaker Lift Stops OperatingTo restore proper lifting strap travel Perform prior to daily use Perform every 36 months Power Rotating Base onlyM a I N T E N a N C E S C H E D U L E Perform every 6 monthsService Checks and Warranty Service THREE-YEAR Transferable Limited WarrantyONE-YEAR Warranty I . W a R R a N T YPage INFMANU3210