Pride Mobility INFMANU3210 manual I . Installation, Power Rotating Base Shroud RE- Moval

Page 8

I I I . I N S T A L L A T I O N

The SilverBoom can be installed in either side of your vehicle. The illustrations demonstrate installation on the right side.

POWER ROTATING BASE SHROUD RE- MOVAL

Installing a power rotating base requires that the base shroud be removed in order to access the rear mounting holes of the L-base. See figure 1.

1.Remove the 4 screws that secure the shroud to the base.

2.Carefully lift the shroud up and off of the base.

NOTE: SilverBoom lifts that have a power rotat- ing base should only be installed into a van or SUV.

DETERMINE L-BASE LOCATION

WARNING! The lift is heavy. Assistance may be necessary during installation. Use proper lifting techniques and avoid lifting beyond your physical capability.

1.Assemble the L-Base. See figure 2. For optimal use, insert the base extensions into the L-base at their farthest extension point and install the hardware (nuts and bolts). The base extensions can be ad- justed to accommodate obstructions.

NOTE: Always insert the bolt from the inside of the L-base. This allows the base extensions to be properly tightened without rattling.

2.Before permanently installing the lift, place the L- base inside your vehicle in the area in which you in- tend to install it. See figure 3 for L-base positioning for SUV’s and vehicles with hatchbacks, or figure 4 for trunk installation.

NOTE: Positioning the L-base close to the rear allows the boom-arm to stay as short as possible; this enables the boom-arm to swing freely without making contact with the motor vehicle.

SCREWS

SCREWS

Figure 1. Power Rotating Base Shroud Removal

BASE EXTENSIONS

L-BASE

BOLT 55 MM (2.5”)

NUT

Figure 2. L-Base Extensions

Figure 3. L-Base (Hatchback Installation)

8

www.silverstarlifts.com

SilverBoom 300

Image 8
Contents SilverStar F E T Y G U I D E L I N E S Phone Number Purchase Date Serial NumberN T E N T S IIIN T R O D U C T I O N Internet and Private Purchases PURCHASER’S AgreementShipping and Delivery Information ExchangeProduct Safety Symbols S a F E T YS a F E T Y Lifting Capabilities Installation Lifting NON-PRIDE ItemsPrelift Inspection Operator PositioningDetermine L-BASE Location I . InstallationPower Rotating Base Shroud RE- Moval Trunk Installation Silverboom 300 Manual Rotation only Assembling the LiftHatchback INSTALLATION- MINIVANS, Station WAGONS, ETC To adjust the height adjustment ringBOOM-ARM Adjustment To adjust the boom-armBase Installation Tools needed for installationMounting Bolts Electrical Wiring Installation Base Cap InstallationFUSE25-AMP Crimp Here Automobile Battery HAND/REMOTE Control Operation O P E R a T I O NTo replace the batteries of the remote control Lifting the Mobility ProductUsing a C-arm BOOM-ARM Manual Rotation Models with a Power Rotating Base Manual Lift Strap OperationTroubleshooting To reset the main circuit breakerLift will not Operate Lift Stops OperatingTo restore proper lifting strap travel Perform every 36 months Power Rotating Base only M a I N T E N a N C E S C H E D U L EPerform prior to daily use Perform every 6 monthsTHREE-YEAR Transferable Limited Warranty ONE-YEAR WarrantyService Checks and Warranty Service I . W a R R a N T YPage INFMANU3210