Heat Controller DMH36TB-1, DMC24DB-1, DMH24DB-1 DMC36TB-1 Connect the cable to the indoor unit

Page 22

Connecting the Cable between Indoor Unit and Outdoor Unit

CAUTION! Provide a circuit breaker between the power source and the outdoor unit as shown below. Size breaker per the Maximum Fuse or

Circuit Breaker (MOC) rating on the unit rating plate.

Main power source

Air

Conditioner

Circuit Breaker Use a circuit breaker or time delay fuse.

Model	Power source

24k	1ø ,230/208V
36k	1ø ,230/208V

Connectthecabletotheindoorunit

1.Connect the wires to the terminals on the control board individually according to the outdoor unit connection.

•Ensure that the color of the wires of outdoor unit and the terminal No. are the same as those of indoor unit respectively.

Connecting cable

2.Attach the Grille onto the cabinet.

•Grasp the lower left and right side of the Grille and engage four tabs on the top inside edge of the chassis.

•Press the Grille toward the chassis until it will be back into place.

22Room Air Conditioner

Image 22

Contents DMC24DB-1, DMH24DB-1 DMC36TB-1, DMH36TB-1 Table of Contents 24k Installation Parts Provided36k Be sure not to do Be sure to follow the instruction Safety PrecautionsThere is risk of fire, electric shock, explosion or injury There is risk of fire or product failure Could cause personal injury Personal injuryMoisture may condense and wet or damage furnishings Oxygen deficiency could occurThere is risk of electrical shock There is risk of fire or electrical shockThere is risk of electric shock There could result in personal injury and product damageThis could damage your health It may cause a problem for your neighborsAvoid personal injury There is risk of damage or loss of propertyThere is risk of personal injury and failure of product It is not sanitary and could cause serious health issuesThere is risk of personal injury Be careful and avoid personal injurySelect the best location Installation of Indoor, Outdoor UnitRooftop Installations Indoor unitMulti Piping Type Piping length and elevation24k 36k Fixing Installation Plate Drill a hole in the wallBurrs removal Flaring workCut the pipes and the cable Putting nut onIndoor Connecting the PipingCheck Foamed polyethylene or equivalent is recommendedKg .mlbf .ft Indoor unit installationOutside diameter Torque Flare nut PipesOpen-end wrench fixed Flare nut Wrench Indoor unit SpacerIndoor unit tubing Piping for Piping holeGood case Bad caseOutdoor Outside diameter Torque Connect the cable to the Indoor unit Connect the cable to the Outdoor unit Power supplyWith the screw How to connect wiring to the terminals Circuit Breaker MOC rating on the unit rating plate Drain piping Checking the drainageTo check the drainage Pour a glass of water on the evaporatorSeal a small Opening around Pipings with Forming the pipingGum type sealer Air Purging and Evacuation Checking methodEvacuation Repeat evacuation procedure for each indoor unitFinishing the job Max total ChargingAdditional Test Running Prepare remote controlEvaluation of the performance Heat CONTROLLER, INC

Related manuals

Manual 70 pages 47.27 Kb

Manual 35 pages 26.68 Kb

Manual 25 pages 18.28 Kb