Heat Controller DMH24DB-1 DMC36TB-1, DMC24DB-1, DMH36TB-1 manual Good case, Bad case

Page 17

Flaring Work and Connection of Piping

Installation Information. For left piping. Follow the instruction below.

Good case

• Press on the upper side of clamp and unfold the tubing to downward slowly.

Bad case

• Following bending type from right to left may cause damage to the tubing.

Installation Manual 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents DMC24DB-1, DMH24DB-1 DMC36TB-1, DMH36TB-1 Table of Contents 36k Installation Parts Provided24k There is risk of fire, electric shock, explosion or injury Safety PrecautionsBe sure not to do Be sure to follow the instruction Moisture may condense and wet or damage furnishings Could cause personal injury Personal injuryThere is risk of fire or product failure Oxygen deficiency could occurThere is risk of electric shock There is risk of fire or electrical shockThere is risk of electrical shock There could result in personal injury and product damageAvoid personal injury It may cause a problem for your neighborsThis could damage your health There is risk of damage or loss of propertyThere is risk of personal injury It is not sanitary and could cause serious health issuesThere is risk of personal injury and failure of product Be careful and avoid personal injuryRooftop Installations Installation of Indoor, Outdoor UnitSelect the best location Indoor unit24k 36k Piping length and elevationMulti Piping Type Drill a hole in the wall Fixing Installation PlateCut the pipes and the cable Flaring workBurrs removal Putting nut onCheck Connecting the PipingIndoor Foamed polyethylene or equivalent is recommended Outside diameter Torque Indoor unit installation Kg .mlbf .ft Flare nut PipesIndoor unit tubing Indoor unit SpacerOpen-end wrench fixed Flare nut Wrench Piping hole Piping forBad case Good caseOutside diameter Torque OutdoorConnect the cable to the Indoor unit With the screw Power supplyConnect the cable to the Outdoor unit How to connect wiring to the terminals Circuit Breaker MOC rating on the unit rating plate To check the drainage Checking the drainageDrain piping Pour a glass of water on the evaporatorGum type sealer Forming the pipingSeal a small Opening around Pipings with Checking method Air Purging and EvacuationFinishing the job Repeat evacuation procedure for each indoor unitEvacuation Additional ChargingMax total Evaluation of the performance Prepare remote controlTest Running Heat CONTROLLER, INC
Related manuals
Manual 70 pages 47.27 Kb Manual 35 pages 26.68 Kb Manual 25 pages 18.28 Kb
Top Page Image Contents