Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
English
Problem | Solution |
No sound | – Adjust the VOLUME |
|
|
Power cord not securely | – Connect AC power cord properly |
connected |
|
|
|
Batteries dead /incorrectly | – Insert (fresh) batteries correctly |
inserted |
|
Display does not function properly/ No reaction to operation of any of the controls
–Electrostatic discharge
–Switch off and unplug the set. Reconnect after a few seconds.
Er indication | – No CD inserted, insert a CD |
|
|
CD badly scratched or dirty | – Replace/ clean CD, see Maintenance |
|
|
Laser lens steamed up | – Wait until lens has cleared |
| – Wait until lens has acclimatized |
– Use a finalized
CD playback does not work | – CD badly scratched/ dirty. Replace/ clean CD (see |
| maintenance) |
|
|
The CD skips tracks | – CD damaged or dirty. Replace or clean CD. |
| – Program is active. Quit program mode |
|
|
Poor cassette sound quality | – Dust and dirt on the heads, etc. |
| Clean deck parts, see maintenance. |
| – Use of incompatible cassette types (METAL or |
| CHROME). Only use NORMAL (IEC I) for recording |
|
|
Recording does not work | – Cassette tab(s) may be broken. Apply a piece of |
| adhesive tape over the missing tab space. |
15