Haier AU142AFBIA, AD142AMBIA When heating is started, Defrosting operation in the heating mode

Page 11

CARE AND MAINTENANCE

"HOT KEEP"is operated in the following cases.

When heating is started:

In order to prevent blowing out of cool wind, the indoor unit fan stopped according to the room temperature which heating operation is started. Wait for approx. 2 to 3 minute, and the operation will be automatically changed to the ordinary heating mode.

Defrosting operation (in the heating mode):

When it is liable to frost. the heating operation is stopped automatically for 5 to 12 minutes once per approx. one hour, and defrosting is operated. After defrosting is completed, operation mode is automatically changed to ordinary heating operation.

When the room thermostat is actuated:

When room temperature increases and room temperature controller actu- ates, the fan speed is automatically changed to stop under low temperature condition of indoor heat exchanger. When room temperature decreases, air conditioner automatically changes over to ordinary heating operation.

WARMING OPERATION

Heat pump type warming

With the heat pump type warming, the mechanism of heat pump that concentrate heat of outdoor air with the help of refrigerant to warm the indoor space, is utilized.

Defrosting operation

When a room is warmed with a heat pump type air conditioner, frost accumulates on the heat exchanger of outdoor unit along with the drop of indoor temperature. Since the accumulated frost reduces the effect of warming, it is necessery to automatically switch the operation to the defrosting mode. During the defrosting operation, heating operation is interrupted.

Atmospheric temperature and warming capacity

Warming capacity of heat pump type air conditioner decreases along with the drop of outdoor temperature.

When the warming capacity is not sufficient, it is recommended to use another heating implement.

Period of warm-up

Since the heat pump type air conditioner employs a method to circulate warm winds to warm the entire space of a room, it takes time before the room temperature rises.

It is recommendable to start the operation a little earlier in a very cold morning.

10

Image 11
Contents Operation & Installation Manual Table of Contents Disposal of the old air conditioner Make sure the system is grounded Safety PrecautionsDo not wash the air conditioner with water Machine is adaptive in following situation Applicable ambient temperature rangeParts and Functions Cooling is not sufficient MalfunctionUnit fails to start Cooling or heating is not sufficientFollowings are not malfunction Points to observe Care and MaintenanceCleaning Atmospheric temperature and warming capacity When heating is startedDefrosting operation in the heating mode When the room thermostat is actuatedInstallation place Installation Manual for Outdoor UnitOpen space requirement around the unit Installation where the area with strong windsInstallation Piping connection Precautions for refrigerant pipingOutline piping Piping sizeInstallation Manual for Outdoor Unit Installation Manual for Indoor Unit Preparation of indoor unit Avoid installation and use at those places listed belowPreparation for suspending the unit 225New cement panel Install the hoisting screwWood structure Requirements Original cement panelSteel structure Suspending of indoor unitConnection of refrigerant pipe Material of connection pipe and thermal insulationConfirm drainage Permitted length and fall of connection pipeElectric wiring Installation Manual for Electric WiringPay attention not to damage PC board Wire. And the two ends of the shieldSet of the air sending of the fan motor Configuration of power supplyInstallation check and test run Check and Test RUN