Hitachi EP-A7000 instruction manual Operation with Max airflow, Will continue for about 5 minutes

Page 13

Max Operation (Air Purify Mode)

This operation is useful when many people smoke or when you want quick cleaning of room air.

 

 

The airflow indicator

blinks for 5 minutes.

Press

button.

 

 

Max(Blinking)

 

 

Auto

 

 

The operation with Max airflow

 

 

Blink

 

 

 

will continue for about 5 minutes.

 

How to cancel

 

 

 

After Max operation, the status

 

 

 

before Max operation is resumed.

Press

button or

button during operation.

 

 

It takes about 10 seconds until the air flow rate reaches Max.

Using Timer

 

 

The timer indicator is lit on.

Press

button.

Pollen

Strong

Skin

Deodorization Humidify

Moisturize Timer(4hrs)

 

On

Off-timer (4 hours) is set.

How to set/cancel

Operation will stop approx.

4 hours after timer setting.Every time you press button, “Set” and “Cancel” will alternate.

Using Remote Controller

E-13

Image 13
Contents EP-A7000 Features / Name of Each Component / Accessories Operation Buttons and Indicators Meanings of Symbols Safety PrecautionsDefinition of each indication Water Tank, Water Tray and Humidifying Filter To Prevent Floor Scratches or Wall Stains Do not directly fan animals and plants Do not subject remote controller to impactDo not run with filter detached Do not subject water tank to impactInstall the dust filter on the unit Install the Deodorizing filterReinstall the panel on the unit Preparations for OperationInsert batteries and close the cover Inserting Batteries into Remote ControllerGently remove the water tank Set the water tank into the water tank holderAir Purify mode indicator is lit in green InstallationRemote controller operation is accepted even in this state Green Installation Using Remote ControllerPollen OrangeAirflow level indicator comes on Using Remote ControllerAirflow rate changes in the following sequence Silent Medium High Blinking MaxOperation with Max airflow Off-timer 4 hours is setWill continue for about 5 minutes Operation will stop approxMemory Function Using the Control on PurifierAir Sensor Odor SensorHumidity Sensor Dust sensorAuto Detection Sensor sensitivity can be adjusted in 3-step fashion Each operation modeFactory setting is Medium Press buttonIndicators are dimmed Useful FeatureEvery time you press button, Set and Cancel will alternate When the Clean Humidifying Filter Indicator Comes On CleaningHumidifying Filter Guide for cleaning Once a month Water Tank Guide for cleaning DailyCleaning Replacing Humidifying Filter Water Tray / Tray Cover Guide for cleaning Once a monthDo not dispose of the humidifying filter case Wipe off water and assembleClean the pre-filter Pre-filterGuide for cleaning Once a monthRemove the panel. P.E-8 Remove the pre-filter Reattach the pre-filterDust sensor Cleaning guide every 3-6 months Purifier Body Guide for cleaning Once a monthReplacement Interval Filter ReplacementPrecautions on Filter Handling Remove the panel and the pre-filter Remove the used filter Replacing the FilterUse a genuine filter for the Hitachi Air Purifier It may also be a cause of malfunctionAlert Display Troubleshooting GuideClean Humidifying Filter indicator does not go off Water leaks Indicator is dimIs there anything nearby that the odor sensor might sense? Following Conditions Are Normal Deodorizing filter 10kg Length of power cord Approx .8mApplicable floor space 50m