Inserting Batteries into Remote Controller
Remove the battery compartment cover.
Cover
Insert batteries and close the cover.
Insert the provided two “AAA” R03 batteries
with the correct polarities as instructed. 
Since the batteries are provided when shipped from
the factory, their lives may be shorter than
Batteries are consumable
When replacing batteries, replace the two batteries simultaneously. 
Only use two manganese batteries or two alkali batteries. Do not mix them.
Preparations
Filling Water Tank (for Humidify Mode and Skin Moisturize Modes)
Gently remove the water tank.
While pressing the upper part of the water tank handle, lift it obliquely upward, and remove the water tank by supporting it in the bottom.
Handle
Remove the tank cap and fill fresh tap water of normal temperature.
Rubber packing
Check that the tank cap is equipped with a rubber packing.
Do not push in the
| Loosen |
| pin in the cap center. |
|
| Tighten | |
|
| Doing so may cause | |
|
|
| |
|
|
| water leakage. |
Handle |
|
| Pin |
|
|
|
for Operation
Hold the water tray.
| Do not carry the water tank by holding its |
| handle. Instead, hold the tank with both |
CAUTION | hands and carry it while keeping the tank |
| cap side up. When the water tank is wet, |
| wipe off water drops before carrying. |
|
|
Press the center pin of the tank cap, and check that it comes back by spring.
Tighten the tank cap firmly, wipe off spilt water, and check that there is no water leakage.
Wipe off water on the water tank handle if any.
The tank cap is a consumable part. 
(If it leaks water due to deteriorated rubber packing, please purchase separately available part for replacement.)
Pull out the water tray, check that the humidifying filter and tray cover are equipped, and then retract the tray.
The humidifying filter absorbs water supplied from the water tank for humidifying operation.
Humidifying filter
Water tray 
Tray cover 
Set the water tank into the water tank holder.
Be sure to handle the 
Press in the tank securely until it clicks. Inadequate setting may cause the water tank to fall or result in water leakage.
Water tray |
| When you remove the water tank, water may |
|
| |
Slowly pull out the water tray while lifting it | CAUTION | drip from the tank cap. Lay a dry cloth before |
obliquely upward. |
| removing the water tank. |
Do not set the water tank without having the water tray in place. Otherwise, the water tank may tip over.
When you pull out the water tray, be careful not to scratch the floor with bottom of the tray.
CAUTION 
Do not leave the detached water tank with its cap closed.
Inner pressure of the tank changes according to ambient temperature change and may cause water leakage or injury due to deformation or damage.
Note | Humidifying function works automatically when the water tank and water tray are filled with water. | |
If you do not need humidification, operate the unit without filling water in the water tank and water tray. | ||
|