Hitachi EP-A7000 instruction manual Operation Buttons and Indicators

Page 3

Operation Buttons and Indicators /

P.E-OOshows a page with further description.

Operation Buttons and Indicators

Humidity Level

P.E-10, 15

Indicates approx. humidity level in the room during operation.

Low Moderate High Orange Orange Green Orange Orange

Operation Mode

P.E-11

Shows the operation mode.

Air Purify, Pollen, Strong

Deodorization

Indicator: Green

Humidify, Skin Moisturize

Indicator: Orange

On/Off Button P.E-14

Use this button to start or stop opera- tion and to switch the operation mode.

Air Sensor

P.E-14

Level of air contamination detected by the dust sensor and odor sensor is shown by how the indicator is lit. (Indicator: Green)

Features / Name of Each Component / Operation

Airflow Level

P.E-12

Indicates airflow rate during operation. (Indicator: Green)

Auto : Airflow rate during auto operation

: Indicates eco operation is active.

When airflow rate is switched using the airflow button on the remote controller, the selected airflow rate is indicated.

: Silent

: Med

: Strong or Max (blinking)

Clean Humidifying

Filter P.E-18

Shows the time to clean the humidifying filter. (Indicator: Red)

Infrared Remote Receiver

Receives remote control signal.

Timer P.E-13

The indicator is lit when 4-hour timer is set. (Indicator: Green)

Buttons and Indicators / Accessories

Remote Controller

Point the remote controller at the infrared receiver on the purifier when you operate.

The remote controllable distance is approx. 6m maximum when pointing the remote controller squarely to the receiver.

On/Off Button P.E-10

Press this button to start or stop operation.

eco Button

P.E-17

Press this button to start or stop eco operation.

Max button

P.E-13

Press this button to start max operation.

Airflow Button P.E-12

Press this button to switch airflow rate.

Mode Button P.E-11

Press this button to switch operation mode.

Timer Button P.E-13

Press this button to set Off-timer.

Sensor Setting Button

P.E-16

Press this button to switch sensor sensitivity.

Note

The remote control may not work in a room where inverter lighting apparatus or electronic quick

 

start lighting apparatus is used, or when the infrared receiver is exposed to direct sunlight.

If you operate the remote controller not pointing straight to the front face of the purifier, the sensitivity will be reduced. Operate the controller from the place in front of the purifier whenever possible.

E-3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents EP-A7000 Features / Name of Each Component / Accessories Operation Buttons and Indicators Safety Precautions Meanings of SymbolsDefinition of each indication Water Tank, Water Tray and Humidifying Filter To Prevent Floor Scratches or Wall Stains Do not subject water tank to impact Do not subject remote controller to impactDo not directly fan animals and plants Do not run with filter detachedPreparations for Operation Install the Deodorizing filterInstall the dust filter on the unit Reinstall the panel on the unitSet the water tank into the water tank holder Inserting Batteries into Remote ControllerInsert batteries and close the cover Gently remove the water tankInstallation Air Purify mode indicator is lit in greenRemote controller operation is accepted even in this state Orange Installation Using Remote ControllerGreen PollenSilent Medium High Blinking Max Using Remote ControllerAirflow level indicator comes on Airflow rate changes in the following sequenceOperation will stop approx Off-timer 4 hours is setOperation with Max airflow Will continue for about 5 minutesOdor Sensor Using the Control on PurifierMemory Function Air SensorDust sensor Humidity SensorAuto Detection Press button Each operation modeSensor sensitivity can be adjusted in 3-step fashion Factory setting is MediumUseful Feature Indicators are dimmedEvery time you press button, Set and Cancel will alternate When the Clean Humidifying Filter Indicator Comes On CleaningWater Tank Guide for cleaning Daily Humidifying Filter Guide for cleaning Once a monthCleaning Wipe off water and assemble Water Tray / Tray Cover Guide for cleaning Once a monthReplacing Humidifying Filter Do not dispose of the humidifying filter caseReattach the pre-filter Pre-filterGuide for cleaning Once a monthClean the pre-filter Remove the panel. P.E-8 Remove the pre-filterDust sensor Cleaning guide every 3-6 months Purifier Body Guide for cleaning Once a monthFilter Replacement Replacement IntervalPrecautions on Filter Handling It may also be a cause of malfunction Replacing the FilterRemove the panel and the pre-filter Remove the used filter Use a genuine filter for the Hitachi Air PurifierAlert Display Troubleshooting GuideWater leaks Indicator is dim Clean Humidifying Filter indicator does not go offIs there anything nearby that the odor sensor might sense? Following Conditions Are Normal 10kg Length of power cord Approx .8m Deodorizing filterApplicable floor space 50m
Top Page Image Contents