Hitachi EP-A7000 Preparations for Operation, Remove the panel, Install the Deodorizing filter

Page 8
Insert into the hole.

Preparations for Operation

CAUTION

Lay a soft cloth or the like beneath the purifier to protect the floor against scratch.

No cleaning effect is obtainable if the filter is installed with plastic bag. It may also be a cause of malfunction. Do not tip over or tilt the purifier.

Setting Filter in Purifier (Perform the same procedure when replacing filter.)

Remove the panel.

Place the unit on a level, stable surface.

Hold the panel at both sides, pull it gently forward and then slightly upward, and remove it.

Remove the pre-filter.

Disengage the tabs of the pre-filter (4 locations).

Remove the filter.

(There are dust filter and deodorizing filter.)

Remove the filter packed in a plastic bag from inside the unit.

Take the filter out of a plastic bag.

Remove the packing.

Be sure to remove the packing.

 

 

Install the Deodorizing filter.

The back

 

(White)

 

Install the deodorizing filter so that its black surface

 

 

faces the front (white surface in the back).

front side(Black)

 

Insert the filter all the way until the label

 

 

(deodorizing filter position indicator) is hidden.

 

 

Note

Be sure to take out the filter from a plastic bag.

Deodorizing filter

White

Do not block the filter front face with cloth or paper.

 

(Black surface)

surface

 

 

 

Same precautions should be taken for the dust filter as well.

Install the dust filter on the unit.

Insert the filter all the way until the label (dust filter position indicator) is hidden.

Install the pre-filter on the unit.

Pre-filter tabs

Dust filter

Reinstall the panel on the unit.

Insert the two tabs on top of the panel into the two holes on the unit.

Gently push bottom of the panel until it clicks to close it securely.

E-8

Image 8
Contents EP-A7000 Features / Name of Each Component / Accessories Operation Buttons and Indicators Definition of each indication Safety PrecautionsMeanings of Symbols Water Tank, Water Tray and Humidifying Filter To Prevent Floor Scratches or Wall Stains Do not subject remote controller to impact Do not directly fan animals and plantsDo not run with filter detached Do not subject water tank to impactInstall the Deodorizing filter Install the dust filter on the unitReinstall the panel on the unit Preparations for OperationInserting Batteries into Remote Controller Insert batteries and close the coverGently remove the water tank Set the water tank into the water tank holderRemote controller operation is accepted even in this state InstallationAir Purify mode indicator is lit in green Installation Using Remote Controller GreenPollen OrangeUsing Remote Controller Airflow level indicator comes onAirflow rate changes in the following sequence Silent Medium High Blinking MaxOff-timer 4 hours is set Operation with Max airflowWill continue for about 5 minutes Operation will stop approxUsing the Control on Purifier Memory FunctionAir Sensor Odor SensorAuto Detection Dust sensorHumidity Sensor Each operation mode Sensor sensitivity can be adjusted in 3-step fashionFactory setting is Medium Press buttonEvery time you press button, Set and Cancel will alternate Useful FeatureIndicators are dimmed Cleaning When the Clean Humidifying Filter Indicator Comes OnCleaning Water Tank Guide for cleaning DailyHumidifying Filter Guide for cleaning Once a month Water Tray / Tray Cover Guide for cleaning Once a month Replacing Humidifying FilterDo not dispose of the humidifying filter case Wipe off water and assemblePre-filterGuide for cleaning Once a month Clean the pre-filterRemove the panel. P.E-8 Remove the pre-filter Reattach the pre-filterPurifier Body Guide for cleaning Once a month Dust sensor Cleaning guide every 3-6 monthsPrecautions on Filter Handling Filter ReplacementReplacement Interval Replacing the Filter Remove the panel and the pre-filter Remove the used filterUse a genuine filter for the Hitachi Air Purifier It may also be a cause of malfunctionTroubleshooting Guide Alert DisplayIs there anything nearby that the odor sensor might sense? Water leaks Indicator is dimClean Humidifying Filter indicator does not go off Following Conditions Are Normal Applicable floor space 50m 10kg Length of power cord Approx .8mDeodorizing filter