Hitachi EP-A7000 Using the Control on Purifier, Memory Function, Air Sensor, Odor Sensor

Page 14

Using the Control on Purifier

Pressbutton.

Operation starts.

Every time you press button, the operation mode switches in the following sequence so that you can choose a desired mode or stop.

Air

 

Pollen

 

Strong

 

Humidify

 

Skin

 

Off

Purify

 

 

 

 

 

Deodorization

 

 

Moisturize

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The airflow rate is set to “Auto” by switching the operation mode.

Memory Function / Sensors / Auto Detection

Memory Function

When you stop the operation and then restart, the purifier will resume the operation status before shutdown. If you operate the purifier for approx. 5 seconds or longer, the operation status will be stored in memory. (If you stop the operation within less than 5 seconds, the operation status will not be stored in memory.) Even if you unplug the power cord, the operation status will be stored in memory. However, the airflow rate is automatically set to “Auto”.

Air Sensor

Level of air contamination detected by the odor sensor, dust sensor is shown by the way the indicator is activated.

Indicator action

: Lit in green

Blink in green

Skin

Air

Contamination level: Clean

Contaminated

Moisturize

Timer(4hrs) Sensor

 

 

Note

Clean

Max(Blinking) Humidifying

You can adjust the air sensor, dust sensor sensitivity setting as desired. P.E-16In case the purifier is installed in a place where air contamination is hard to detect

or in case the sensor itself is not clean, the indicator action may not change. P.E-25

Filter

Odor Sensor

The sensor detects odor in air such as cigarette smoke or odor of pet animals.

 

Even when you feel the air is clean, the purifier may continue the operation if the

 

odor sensor finds any gas component not removed by the filter.

 

Any of the following may also be detected by the odor sensor.

 

Combustion gas from heating appliance, alcohol, odor of perfumes or cosmetics

 

used in beauty parlor or aesthetic salon, sprays, vapor, abrupt temperature

Odor sensor

change, etc.

E-14

Image 14
Contents EP-A7000 Features / Name of Each Component / Accessories Operation Buttons and Indicators Definition of each indication Safety PrecautionsMeanings of Symbols Water Tank, Water Tray and Humidifying Filter To Prevent Floor Scratches or Wall Stains Do not run with filter detached Do not subject remote controller to impactDo not directly fan animals and plants Do not subject water tank to impactReinstall the panel on the unit Install the Deodorizing filterInstall the dust filter on the unit Preparations for OperationGently remove the water tank Inserting Batteries into Remote ControllerInsert batteries and close the cover Set the water tank into the water tank holderRemote controller operation is accepted even in this state InstallationAir Purify mode indicator is lit in green Pollen Installation Using Remote ControllerGreen OrangeAirflow rate changes in the following sequence Using Remote ControllerAirflow level indicator comes on Silent Medium High Blinking MaxWill continue for about 5 minutes Off-timer 4 hours is setOperation with Max airflow Operation will stop approxAir Sensor Using the Control on PurifierMemory Function Odor SensorAuto Detection Dust sensorHumidity Sensor Factory setting is Medium Each operation modeSensor sensitivity can be adjusted in 3-step fashion Press buttonEvery time you press button, Set and Cancel will alternate Useful FeatureIndicators are dimmed Cleaning When the Clean Humidifying Filter Indicator Comes OnCleaning Water Tank Guide for cleaning DailyHumidifying Filter Guide for cleaning Once a month Do not dispose of the humidifying filter case Water Tray / Tray Cover Guide for cleaning Once a monthReplacing Humidifying Filter Wipe off water and assembleRemove the panel. P.E-8 Remove the pre-filter Pre-filterGuide for cleaning Once a monthClean the pre-filter Reattach the pre-filterPurifier Body Guide for cleaning Once a month Dust sensor Cleaning guide every 3-6 monthsPrecautions on Filter Handling Filter ReplacementReplacement Interval Use a genuine filter for the Hitachi Air Purifier Replacing the FilterRemove the panel and the pre-filter Remove the used filter It may also be a cause of malfunctionTroubleshooting Guide Alert DisplayIs there anything nearby that the odor sensor might sense? Water leaks Indicator is dimClean Humidifying Filter indicator does not go off Following Conditions Are Normal Applicable floor space 50m 10kg Length of power cord Approx .8mDeodorizing filter