Hitachi EP-A7000 instruction manual Press button, Each operation mode, Factory setting is Medium

Page 16

Memory Function / Sensors / Auto Detection (Continued)

Adjusting Sensor Sensitivity Setting

Sensor sensitivity can be adjusted in 3-step fashion.

In each operation mode,

press button.

(Use the tip of a ball-point pen or the like.)

The airflow indicator will blink for 5 seconds.

Present setting is shown by the airflow indicator that blinks for 5 seconds.

Air Purify	Pollen	Strong	Humidify	Skin
		Deodorization		Moisturize
Auto		Blink	Max(Blinking

Every time you press the button, the setting switches.

(Low) (Medium) (High)

While the airflow indicator is blinking,

press button.

The factory setting is “Medium”.

E-16

Image 16

Contents EP-A7000 Features / Name of Each Component / Accessories Operation Buttons and Indicators Meanings of Symbols Safety PrecautionsDefinition of each indication Water Tank, Water Tray and Humidifying Filter To Prevent Floor Scratches or Wall Stains Do not subject remote controller to impact Do not directly fan animals and plantsDo not run with filter detached Do not subject water tank to impactInstall the Deodorizing filter Install the dust filter on the unitReinstall the panel on the unit Preparations for OperationInserting Batteries into Remote Controller Insert batteries and close the coverGently remove the water tank Set the water tank into the water tank holderAir Purify mode indicator is lit in green InstallationRemote controller operation is accepted even in this state Installation Using Remote Controller GreenPollen OrangeUsing Remote Controller Airflow level indicator comes onAirflow rate changes in the following sequence Silent Medium High Blinking MaxOff-timer 4 hours is set Operation with Max airflowWill continue for about 5 minutes Operation will stop approxUsing the Control on Puriﬁer Memory FunctionAir Sensor Odor SensorHumidity Sensor Dust sensorAuto Detection Each operation mode Sensor sensitivity can be adjusted in 3-step fashionFactory setting is Medium Press buttonIndicators are dimmed Useful FeatureEvery time you press button, Set and Cancel will alternate Cleaning When the Clean Humidifying Filter Indicator Comes OnHumidifying Filter Guide for cleaning Once a month Water Tank Guide for cleaning DailyCleaning Water Tray / Tray Cover Guide for cleaning Once a month Replacing Humidifying FilterDo not dispose of the humidifying filter case Wipe off water and assemblePre-filterGuide for cleaning Once a month Clean the pre-filterRemove the panel. P.E-8 Remove the pre-filter Reattach the pre-filterPurifier Body Guide for cleaning Once a month Dust sensor Cleaning guide every 3-6 monthsReplacement Interval Filter ReplacementPrecautions on Filter Handling Replacing the Filter Remove the panel and the pre-filter Remove the used filterUse a genuine ﬁlter for the Hitachi Air Puriﬁer It may also be a cause of malfunctionTroubleshooting Guide Alert DisplayClean Humidifying Filter indicator does not go off Water leaks Indicator is dimIs there anything nearby that the odor sensor might sense? Following Conditions Are Normal Deodorizing filter 10kg Length of power cord Approx .8mApplicable floor space 50m