Preparing the combination unit for operation

Preparing the combination unit for operation

Remote control

1Open the battery compartment on the back of the re- mote control and remove the cover of the

battery comparment.

2Now put in two batteries type AAA/LR 03 (round cells, not included in the scope of supply) into the battery compartment. Take care that the batteries are inserted with the correct polarity.

3Put the cover of the battery compartment back on to the back of the remote control.

Replacing the batteries:

If the combination unit cannot be operated properly with the remote control or does not work at all, the batteries must be replaced.

Always replace both batteries, in order to be able to use the remote control at full capacity again.

Note:

Used batteries may not be disposed of in household waste. Throw away used batteries at a waste collection or disposal point or there, where you bought the batteries.

If you should want to dispose of the remote control of the combination unit itself, then you have to remove the batteries beforehand!

Note

To guarantee that the remote control works perfectly:

•Always point the remote control at the combination unit

•Ensure that there are no obstacles between the re- mote control and the combination unit, which pre- vent reception

•Do not move more than 5 meters away from the combination unit when using the remote control

Otherwise disturbances can arise when operating the combination unit with the remote control.

Connecting the combination unit to a television

After having set up the combination unit, you can now connect it to a television. The combination unit can be connected to a television with PAL, NTSC and SECAM tel- evision standards.

If you would like to use the combination unit with a televi- sion with

•NTSC standard, then you have to change the video set- tings of the combination unit. This can be done in the so-called OSD menu of the combination unit. There you will find that PAL has been set by the factory as the television standard.

•SECAM standard, then you do not have to make any changes to the settings in the OSD menu. The settings for the PAL standard also enable the combination unit to be operated with SECAM television sets. However to do this, SECAM televisions sets must be able to process PAL signals.

Depending on the type of television, there are different possibilities of connecting the combination unit to it:

Connecting to a television by means of a scart cable/RGB

Note:

The best quality connection is achieved by connecting the combination unit to the television by means of a scart ca- ble via the RGB input. Choose this connection variant if the television has an RGB input. If you are not sure, check this by looking at the operating instructions of the television.

To connect the combination unit to a television by means of a scart cable:

1Plug the supplied scart cable into the scart jack of the combination unit.

2Plug the other end of the scart cable into the scart jack of the television.

3Set the television to RGB mode in the AV channel. If you are not sure how to carry out this setting, then consult the operating instructions of the television.

Also look at the chapter “Setting video output” for more information on this subject.

KH 2370