Extron electronic DVS 304 AD, DVS 304 D 6- Wiring the RJ-45, Installation and Operation, cont’d

Installation and Operation, cont’d

Pins:

1 2 3 4 5 6 78

Side View

Insert

Twisted

Pair Wires

RJ-45 Connector

Straight-through Cable

(for connection to a switch, hub, or router)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-orange
2	orange	2	orange
3	white-green	3	white-green
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	green
7	white-brown	7	white-brown
8	brown	8	brown

Crossover Cable

(for direct connection to a PC)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-green
2	orange	2	green
3	white-green	3	white-orange
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	orange
7	white-brown	7	white-brown
8	brown	8	brown

Figure 2-6 — Wiring the RJ-45

K	Remote (RS-232/contact closure) 9-pin port — This connector
	provides for two-way RS-232 communication. See chapter 3,
	“Serial Communication”, for information on how to install and
	use the control software and SIS commands.

RS-232

51

96

The default protocol is 9600 baud, 1 stop bit, no parity, and no flow control.

The rear panel RS-232 9-pin D female connector has the following pin assignments:

Pin	RS-232 function	Description
1	Input #1	Contact closure
2	Tx	Transmit data
3	Rx	Receive data
4	Input #2	Contact closure
5	Gnd	Signal ground
6	Input #3	Contact closure
7	Input #4	Contact closure
8	–	No connection
9	–	Reserved

The Remote connector also provides a way to select an input using a remote contact closure device. Contact closure control uses pins on the RS-232 connector that are not used by the RS-232 interface (see preceding table).

To select a different input number using a contact closure device, short the pin for the desired input number to logic ground (pin 5).

2-8 DVS 304 • Installation and Operation